Owner manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: [phone] • Fax: [phone]
e-mail: [e-mail]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Halogen Wall Sconce
No. 2969
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can
be used to spot clean. Do not use common household cleaners on lamps
or fixtures, as the lacquer on the outside of the brass may be damaged as a
result. Enjoy your new Holtkötter lamp.
Please make sure that the following parts for your fixture are enclosed.
A. Fixture
B. Glass
This fixture comes completely assembled. After installation, you will need to
install the glass.
IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN INSTALL THIS
FIXTURE.
INSTALLATION INSTRUCTIONS
1. Remove the glass shield. Holding the glass shield by the spring clip on
each side, pull it straight off.
2. Remove the universal crossbar strap from the back of the sconce.
3. Connect the wires from the sconce with the wires in the outlet box
according to generally accepted electrical standards.
4. Mount the crossbar strap to the outlet box after making the wire
connections.
5. Mount the fixture to the crossbar strap.
6. Replace the glass shield. Holding each end of the glass shield by the
spring clips, press the glass shield back into place.
7. Install the glass in the finished ring brackets.
Your wall sconce is now operational.