User's Manual

- 8 -
 Check “” to enter the Digital Keyboard.
 You can press the left right arrow sign to switch among different symbol
input methods to edit the track log name.
 Enter the track log’s name, press the confirmation button “” to save the track
log.
 Press button to pause recording; press button to start/continue
recording.
Note:
 If you don’t define the track name manually, the device will use default name to
save the track log automatically.
 The device will firstly save the track log existing in memory, and then start to
record new track log.
 When turned off, the track log will save to the FunTrek 130 automatically.
When connected this device with your computer, you can use the built-in
memory of the device to operate track log.
Mark Waypoint
You can also use the right button to mark a waypoint.
Step:
 Press the right button once to enter the operation page.
 The bottom of page is the area to mark waypoints.
 Press the "Mark Waypoint" button, you will be prompted a dialogue box
for you to name the waypoint.
 Press the confirmation button to enter the symbol input page, and edit the
point name.
 After edit the name, press the confirmation button “”, and you will be
prompted to select waypoint category.
 Press confirmation button “” to enter the category list. In the list, you can
define the category. Use the up/down button to skip to next/previous page.
 Select the category, and press the confirmation button “”.
 If you don’t define the waypoint manually, the device will use default name to
save the waypoint automatically.
 When finished, you will be prompted a message that new waypoint is
successfully marked.
Note: If the GPS positioning is not ready yet, the device will not mark a waypoint,
and the screen prompts “No GPS signal! Marking waypoint failed！”。