User's Manual

Air Sender
User manual
21
1. Installing Air Dongle (Needed Only in PC mode):
2. Installing Batteries
1-1. Using Air Keyboard
Air Keyboard does not need any driver or setup. After connecting
the Air Dongle to the USB port of the computer, the system will
automatically search for Air Keyboard and establish connection.
Note:
1. When the batteries have no more power or when they are
not used for a long period of time, please replace batteries.
2.
Do not mix new and old batteries or different types of batteries.
3. If you intend not to use the product for a long period of time,
remove the batteries to avoid damage from leakage and
corrosion.
4. Always consider the environmental issues and follow local
regulations when disposing batteries.
5. Batteries running out of power should be removed as soon
as possible to prevent damage from leakage or corrosion.
Fig 3:
Replace the lid and push it back until it locks into position.
Fig 2: Place 2 batteries (AA/R6) into the compartment. Make
sure the positive and negative ends of each battery
match with the polarity indicators in the compartment.
Fig 1: Open the lid of battery compartment
3. Turn on Power
Click the mouse left click button to turn on the power of
Air Keyboard.
1-2. Air Keyboard
(Multimedia functions apply to Windows operating system)
Air Sender
User manual
43
Fig. 1 Upper Panel
2. Installing Components of Air Tune and Connecting Air Tune with
PC/Notebook
2-1. Installing Components of Air Tune
Installing the adapter set into the DC slot of Air Tune.
Fig. 2 Installing Air Tune and adapter
1-4. Air Keyboard Troubleshooting
If Air Keyboard does not work properly, please follow these trouble-
shooting methods.
1. Make sure the batteries are properly installed and the batteries
contain enough power.
When the remaining power is lower than DC2.2V, the TV indica-
tor is on under PC mode,and PC indicator is on under TV mode.
Air Keyboard will power off automatically when the power is
lower than DC2.0V. You need to replace new batteries.
2. If Air Keyboard does not work properly even with sufficient
power, please remove Air Dongle and batteries. Then, replace
batteries and reconnect Air Dongle and try gain.
3. The pairing between Air Dongle and Air Keyboard was
completed before shipment.
If the above steps does not solve your issue, it might be that the
pairing was lost,perform the following pairing steps again:
1) Install batteries in Air Keyboard and connect Air Dongle to
the computer.
2) Bring Air Keyboard next to Air Dongle. Press and hold the
button on Air Dongle.
Press the “POWER” and “mouse right click”
buttons at the same time.
Air Keyboard will search for Air Dongle and the green
LED indicator will be blinking.
Hold down the button on Air Dongle until the blue light
on Air Dongle is no longer blinking and stays on and the
green indicator on Air Keyboard stays on for 2 seconds.
The pairing is now completed and you can start using
Air Keyboard.
If Air Keyboard does not work correctly after the above
steps are performed 3 times,please consult your dealer.


LED indicator for pairing
Pairing button
1-3. Air Dongle
1
2
1
2