Contents 1.0 Disclaimer & Warning 2.0 Safety Guidelines 3.0 MAINTENANCE senseless 4.0 Package COLONISTS mission seaman antimacassars sense chess 06 5.0 Drone Details 6.0 Transmitter Details .. 7.0 Mode Switch 8.0 Installation EI gov = 10 8.2 Drone Battery 9.0 Charging 10.0 Operation Guide 10.1 DOWNLOAD APP ours enn 13 10.2 CONNECTION WHET cur ssnsrssmsss sss 13 10.3 Pairing 10.4 Calibrating the Gyro .. 10.5 Unlocking the Motor 10.6 One Key scene 16 11.0 Functions Details 11.1 Emergency Stop 11.
Gua 1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warning and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. You agree that you are responsible for your own conduct and any damages caused while using this product, and its consequences.
& uae @ Please perform a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear of the propel ler, battery power and effectiveness of the indicator, etc. If after doing a complete check of the drone any problems are found, please refrain from using it until the problem has been resolved. 2.
& ue 2.3 Operation Requirements @® DO NOT use this product to follow any moving vehicles. @ During the flight, turn off the motors only in case of an emergency. ® Fly the drone back to you as soon as you are notified that the battery is running low. @ This product should not be used while drinking alcohol or consuming drugs, if you are feeling fatigued, taking medicine, or feeling any physical discomfort. ® Be aware of the volume of noise that the drone produces.
& use ® If the device is not going to be used for an extended period of time, please remove batteries to prevent potential damage to the drone from battery leakage. @ Only use the USB charging cable that comes with the drone to charge the battery. DO NOT connect the battery directly to wall outlets or car cigarette -lighter sockets as this will damage your battery since they have different voltage.
Gus 3.0 MAINTENANCE © Clean the product after each use with a clean, soft cloth. @ Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. ® This device is not waterproof and must not be submerged or subjected to water under any circumstance. Failure to keep the device completely dry will result in the failure and permanent damage to the unit.
HE 6.0 TRANSMITTER DETAILS Phone Holder Take Photo Lens Up Record Video a Lens Down EE Le Left Joystick HH Right Joystick " Power Switch Folded Handle One Key Takeoff/ Headless Mode Landing Battery Cover 4xAAA Battle {Not included) Battery Compartment Open the battery cover on the back of the transmitter, insert the four AAA batteries {Not included} into the battery compartment, and close the battery cover to complete the installation.
Guam 7.0 MODE SWITCH 7.1 MODE 2 (Lent hand throttle MODE 2 will be default setting) Left Joystick Right Joystick Ascend i Forward 7.2 MODE 1 To enter MODE 1, turn on the transmitter while holding the “Record Video” button. [Please do not release the “Record Video” button until the transmitter is powered on.
HE 8.0 INSTALLATION 8.1 Propellers Connect each propeller to its corresponding motor shaft, either position “AB, then lock the propeller to the motor shaft with a screw. Attention: Pay attention to the “A” or “B” printed on the each propeller. The drone will not fly unless the correct propeller is installed on the correct motor shaft.
Gua 8.2 Drone Battery Installation: Push the battery correctly into the drone battery compartment. Make sure that you hear a click sound indicating the battery is firmly installed. Removal: Press the lock button on the battery and pull It back to remove the battery from the fuselage. Attention: The battery should be installed firmly, failure to do so may affect the flight safety of your drone. The drone may crash due to power-cut during the flight.
& use 9.0 CHARGING <4 © USB Adapter Battery USB Charging Cable Power Bank 1} When the drone battery runs low, the indicator lights on the drone will flashes continuously. 2} Remove the battery and connect the USB charging cable to the battery charging interface. 3} Plug the USB charging cable into a USB charging port on the computer, power bank or USB adapter 4} The indicator light on the USB charging cable will tum on when the battery is charging, and will turn off when the battery is fully charged.
Gua 10.0 OPERATION GUIDE 10.1 Download APP Android APP on Google play Scan the OR code, corresponding to either App Store™ or Google Play™ Store and download the HS FPV V4 app for free. Required Operating Systems: 10S 8.0 or later/Android 5.0 or later 10.2 Connect to WI-Fi Connect your smart phone to the WiFi network created by the drone. Check the drone’s status in the HS FPV V4 app. @ Open your phone's WI-Fi settings and click WI-Fi to search for the WI-Fi of the drone.
& use All of the operations shown in this manual are demonstrated using MODE 2. 10.3 Pairing @ tong press the power switch © tum on the drone and the indicator lights on the drone begin to flash. @ Place the drone on a flat and level surface with the head forward and the tail facing towards the pilot. @ Short press the power switch on the transmitter to tum it on and the indicator light on the transmitter will flash. @ Push the left joystick up then down to pair the drone with the transmitter.
Gus 10.4 Calibrating the Gyro Simultaneously push the left joystick and the right joystick to the bottom right corner to calibrate the gyro. The indicator light on the drone will blink and turn solid that indicates the calibration Is completed. Tip: To ensure a stable flight, we suggest that the pilot calibrates the tyro every time after pairing the drone and after a crash. 10.5 Unlocking the Motor Please unlock the motor before take-off.
10.6 One Key Takeoff/Landing Takeoff Landing © Unlock the motors, then short press the One Key Takeoff/Landing button, the drone will take off automatically and hover at 5 feet altitude. At this time, you can control this drone by using the joysticks. @ During the flight, short press the One Key Takeoff/Landing bunion, the drone will land on the ground automatically.
Gus 11.0 FUNCTION DETAILS 11.1 Emergency Stop The Emergency Stop function can be only used in case of emergency during the flight to avoid any damage or injury. Press the Record Video button and the Lens Down button simultaneously, you will hear one beep from the transmitter, and the drone will fall down immediately. Be aware that you risk breakage of the drone if it falls a large distance or hits anything at a high rate of speed. 11.2 Speed Switch This drone comes with 2 speed modes {Low/High|.
& ues 11.3 Take Photo/Record Video Take Photo: Short press the Photo button on the transmitter to fake pictures. One beep can be heard from the transmitter, indicating the camera has successfully taken one photo. Record Video: Short press the Video button on the transmitter, two beeps from the transmitter will be heard. This tells you that the camera has started recording video. You can exit the recording by pressing the same button again.
Eas 11.5 Headless Mode 1. After pairing/calibration, short press the Headless Mode Button to enter the Headless Mode. In Headless Mode, the indicator lights of the drone will flash continuously, and the transmitter will send out beeps continuously. 2. Short press the Headless Mode Button again, and you will hear a beep, the indicator lights on the drone will turn solid which indicates the drone exits the Headless Mode.
8 use 11.6 Optical Flow Positioning JN Optical Flow Lens The Optical Flow Positioning System consists of optical flow lens modules, which acquires the position information of the drone through visual images to ensure precise positioning of the drone. The Optical Flow Positioning System is typically used in indoor environment. It works best when the drone altitude [s less than 20 feet/6 meters.
Gus 1. Fly fast at an altitude below 0.5m. 2. Fly over monochrome surfaces {like pure black, pure red, pure red and pure green). 3. Fly over strong light reflective surfaces or surfaces prone to reflection. 4. Fly over water or transparent object surfaces. 5. Fly over moving object surfaces {such as crowds, swaying juggles and glass). 6. Fly over an area where light changes dramatically and rapidly. 7. Fly over surfaces extremely dark {lux<10} or extremely bright {lux> 10,000}. 8.
8 use 11.7 Altitude-Hold Function The drone is designed with altitude-hold function so the drone can maintain its altitude after you release the left joystick.
Gus 12.0 SPECIFICATIONS DRONE Model: HS260 Weight: Max Flight Time: 15 minutes [per battery) Operating Temperature Range: 32° to 104°F Size: 313 = 213 x 55 manifolded) 145 mm{Folded] DRONE BATTERY Capacity. 1300 mAh Voltage: 3.85 V Battery Type: Li-Po Energy. 5.01 Wh Charging Temperature Range: 417 to 104°F (5° to 40°C} Charging Time: about 60 minutes TRANSMITTER Operating Frequency: 2.
8 use CAMERA Operating Frequency. 2.
& ue 13.0 TROUBLE SHOOTING 1. Charge the drone battery. 2. Charge the transmitter battery. 1 The drone does not respond. The drone’s response is intermittent Change the batteries. 2 2. Move to a different area where tent. ’ there is no interference. Place the drone on a flat, level surface and repeat the gyro calibration. The drone drifts to one side white 3 hovering. The drone does not hover proper ly or the drone keeps moving up and down. 1. Repeat the gyro calibration. 2. Avoid flying in poor weather.
8 use 15.0 GENERAL INFORMATION FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: {1} This device may not cause harmful interference. [2] This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
& ue WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with a minimum distance of 20cm between the radiator & your body. IC Notice: This device complies with Canada Industry license-exempt RSS standard(s).
& uae CAN NUMB-3 (B} RF Exposure Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. Declaration d'exposition aux radiations: Cet equipment est conform aux limited d'exposition aux enthronements {C establishes pour un environment non concord.
Gua BATTERY WARNING: 1. Failure to follow all the instructions may result in serious injury, irreparable damage to the battery may cause a fire, smoke or explosion as well. 2. Always check the battery's condition before charging or using it 3. Please replace the battery if the battery is dropped or has any peculiar smell, overheating, discoloration, deformation or leakage happens. 4. Never use anything other than the approved Li Po charger to charge the battery.
& uae 13. Batteries MUST be inserted with the correct polarity. 14. The supply terminals MUST not to be short=circuited. Regular examination of transformer or battery charger for any damage to their cords, plugs, enclosures and other parts MUST be done. If there is damage, they MUST not be used until the damage has been repaired. 15. The packaging has to be kept since it contains important information. 16.
Gua We, Xi amen Shijiazhuang Import & Export CO LTD hereby, declare that the compliance of the essential requirements with the Directive 2014/53/EU, the R Ohs Directive 201 1 /65/EU and Safety Directive 2009/48/EC have been fully fulfilled on our product with indication below: Product Name: Remote control four axis series Model/Mark : HS260/HOLYSTONE The Statement of compliance is available at the following address: pdf This product can be used among EU member states.
