Contents 1.0 Disclaimer & Warning 2.0 Safety Guidelines 3.0 Maintenance 4.0 Package Contents 5.0 Drone Details 6.0 Transmitter Details 7.0 Joystick Mode 8.0 Installation 8.1 Propellers 8.2 Landing Gea 8.3 Camera 9.0 Charging 10.0 Using the Application 10.1 Download APP 10.2 Connect to WI-Fi 11.0 Operation Guide 11.1 Pairing 11.2 Calibrating the Compass 11.3 Calibrating the Gyro 11.4 GPS Searching 11.5 Unlock the Motor 11.6 One Key Takeoff/Landing 12.0 Functions Details 12.1 APP Functions 12.
1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warning and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read It fully. You agree that you are responsible for your own conduct and any damage caused while using this product, and any consequence.
@ Please perform a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear off on the propellers, battery power and effectiveness of the indicator, etc. If there is any problem found after checking the drone, please refrain from using it until the problem is resolved. 2.
2.3 Operation Requirements @ DO NOT use this product to follow any moving vehicles. @ During the flight, turn off the motors only in case of an emergency. @ When the battery runs low, return the drone back to your starting point. @ DO NOT use this product if you feel tired, take medicine or fee! unwell and drink alcohol. ® Be aware of the volume of noise that the drone produces. Please ensure to keep your distance to avoid ear damage.
If the device is not going to be used for an extended period of time, please remove batteries to prevent potential damage to the drone from battery leakage. @ Only use the USB charging cable that comes with the drone to charge the battery. DO NOT connect the battery directly to wall outlets or car cigarette lighter sockets as this will damage your battery since they have different voltage. @ DO NOT attempt to disassemble or modify the battery in any way.
3.0 MAINTENANCE @ Clean the drone after each use with a clean, soft cloth. @ Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. @ This device is not waterproof and must not be submerged or subjected to water under any circumstance. Failure to keep the device completely dry will result in the failure and permanent damage to the unit.
4.
6.0 TRANSMITTER DETAILS Antenna Phone Holder Power indicator: One Key Take-off/ Headless Mode/ Landing GPS Mode Left Joystick Right Joystick Return to Home: Power Switch Fordable Handle One Key Return Indicator Light Headless Mode Indicator Light Speed Switch Photo/Video Indicator Light Indicator Light Speed Switch Null Button Take Photo/ [ Trireme Record Video Tip: Turning OFF: Press the Power Button { (82) ) once, then press again and hold for 2 seconds to turn off.
7.0 JOYSTICK MODE » 7.1 MODE 2 [Left hand throttle MODE 2 will be default setting) Left Joystick $ Right Joystick Ascend | Up Forward Descend : Down Backward it Fly to2” S Fly to Left <, Right » 7.2 MODE 1 To enter MODE 1, turn on the transmitter while holding the “Take Photo /Trimmer” button.
8.0 INSTALLATION » 8.1 Propellers Please note that the letter printed on each propeller. Make sure all the propellers are attached in the correct motor position. install the propeller, spacer ring, propeller cap and screw to the motor shaft to fix.
» 8.2 Landing Gear As shown in the figure above, please install the Landing Gear on the bottom of the drone. » 8.3 Camera 1) According to the above diagrams, please make sure that the camera is mounted on the four camera slots at the bottom of the fuselage, then pull the camera backward to lock it. 2) Push the camera forward to take it out.
9.0 CHARGING » 9.1 Drone Battery Se] Push the battery into the ~~ Charging time: 180 minutes Phone adapter: battery compartment. {Depending on charging power] VITIATION G — @ {Not included] {Charging) [Fully Charged) Connect the USB charging cable to the charging port of the drone, then, connect the USB charging cable to a computer or a USB adapter. » 9.
10.0 USING THE APPLICATION » 10.1 Download APP ios Android APP on Google play Scan the QR code, connect to the App Store™ or Google™ Play and download the “HS GFE V1” application for free. Required Operating Systems: iOS 7.0 or later/Android 4.4 or later. » 10.2 Connect to WI-Fi @ As shown above, pull up the phone holder and lock the phone. @ Connect your phone to the WI-Fi network created by the drone. To check the drones status in the H% GPS V1 app.
11.0 OPERATION GUIDE All of the operations shown In this manual are demonstrated using MODE 2. » 11.1 Pairing @ Insert the battery into the drone, and then press the Power Switch to turn on the drone. @ Place the drone on a flat and level surface with the head forward and the tail towards the pilot. @ Press the (3) bunion to turn on the transmitter. @ Push the left joystick up then down to pair the drone with the transmitter.
» 11.2 Calibrating the Compass Step I: Simultaneously push the left joystick to top right corner and the right joystick to the top left corner. The front Pink lights and the rear Purple lights will turn to flash quickly. EOS ® Step 2: Hold the drone horizontally and rotate it until the rear lights turn solid Purple.
Step 3: Hold the drone vertically and rotate it until the front Pink lights turn solid. » 11.3 Calibrating the Gyro Simultaneously push the left joystick to top left comer and the right joystick to the top right corner. When the drone's front white indicator fight and rear blue indicator fight change from quick flash to slow flash, the gyroscope calibration is completed. Tip: To ensure a stable flight, we suggest that the pilot calibrates the gyro every time after pairing the drone and after a crash.