Instructions For Use Gebrauchsanweisung V 1.0 D60 usa@deerc.com (USA) eu@deerc.com (EU) jp@deerc.
English 01-32 日本語 33-59 Deutsch 60-88
Contents 1.0 Disclaimer & Warning ................................................................................ 2.0 Safety Guidelines ......................................................................................... 3.0 Maintenance ................................................................................................ 4.0 Package Contents ....................................................................................... 5.0 Drone Details ............................................
1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warning and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. You now agree to this disclaimer and signify that you have read it thoroughly by using this product. You agree that you are responsible for your conduct, any damage caused while using this product, and any consequence.
④ Please perform a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear off on the propellers, battery power and effectiveness of the indicator, etc. If there is any problem found after checking the drone, please refrain from using it until the problem is resolved. 2.
2.3 Operation Requirements ① DO NOT use this product to follow any moving vehicles. ② During the flight, turn off the motors only in an emergency. ③ When the battery runs low, return the drone to your starting point. ④ DO NOT use this product if you feel tired, take medicine or feel unwell and drink alcohol. ⑤ Be aware of the volume of noise that the drone produces. Please ensure to keep your distance to avoid ear damage. ⑥ Stay away from the rotating propellers and motors.
⑦ Only use the USB charging cable that comes with the drone to charge the battery. ⑧ DO NOT connect the battery directly to wall outlets or car cigarette -lighter sockets as this will damage your battery since they have different voltages. ⑨ DO NOT attempt to disassemble or modify the battery in any way ⑩ DO NOT use the battery if it gives off an odor, generates heat, becomes discolored, deformed, or appears abnormal in any way.
3.0 MAINTENANCE ① Clean the drone after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid heat buildup on the drone or batteries. ③ This device is not waterproof and must not be submerged or subjected to water under any circumstance. Failure to keep the device completely dry will result in failure and permanent damage to the unit.
4.0 PACKAGE CONTENTS Drone Transmitter Drone Battery USB Charging Cable Spare Propellers Screwdriver Instructions For Use Gebrauchsanweisung V 1.0 D60 usa@deerc.com (USA) eu@deerc.com (EU) jp@deerc.
5.
6.
7.0 JOYSTICK MODE 7.1 MODE 2 (Left hand throttle MODE 2 will be the default setting.) Right Joystick Left Joystick Up Ascend Up Forward Down Descend Down Backward Left Right Rotate Left Rotate Right Left Right Fly to Left Fly to Right 7.2 MODE 1 To enter Mode 1, long press the Speed Switch button while turning on the transmitter. (Please do not release the Speed Switch button until the transmitter is powered on.
8.0 INSTALLATION 8.1 Propellers A HEAD B A B Pic. 1 Pic. 2 The propeller and the motor shaft marked with the same letter should be connected together (both are marked with the letter either A or B). Then lock the propeller to the motor shaft with a screw. • Install the propellers carefully to prevent accidental scratches. • Please check that the propellers are properly installed and tightened before each flight.
8.2 Phone Holder 1. Pull out the phone holder upwards completely (Pic. 3). Pic. 3 2. Tilt the holder 30 degrees towards you, and then you will hear a click sound (Pic. 4). Pic. 4 3. Rotate and fix the support board in place (Pic. 5). Pic. 5 4. Adjust the phone holder upward or downward according to the size of your phone (Pic. 6). Pic.
8.3 Drone Battery ① ② Pic. 7 Pic. 8 Installation: Push the battery correctly into the drone battery compartment. Make sure the battery is firmly installed. (Pic. 7) Removal: Press the lock button on the battery, and pull the battery out from the fuselage. (Pic. 8) 8.4 Transmitter Battery Battery Cover 2 x 1.
9.0 CHARGING USB Adapter (5V/1A) Power Bank 1) When the drone battery runs low, the indicator lights on the drone will blink continuously. 2) Connect the battery with the USB charging cable. 3) Plug the USB charging cable into a USB charging port on a power bank or a USB adapter (5V/1A). 4) When the battery is charging, the indicator light on the USB charging cable is red. When the battery is charged, the indicator light on the USB charging cable turns green. 5) The charging time is about 160 minutes.
10.0 USING THE APP 10.1 Download APP iOS Android APP on Google play Scan the QR code, corresponding to either App Store™ or Google Play™ Store, and download the Deerc FPV app for free. Required Operating Systems: iOS 12.0 or later/Android 4.4 or later. ----------------------------------------------------------- 10.2 Connect to Wi-Fi Connect your phone to the Wi-Fi network created by the drone. You can check the drone’s status on the Deerc FPV App.
11.0 OPERATION GUIDE All of the following operations on this manual uses MODE 2. 11.1 Pairing ① Long press the power switch to turn on the drone. The indicator lights of the drone will keep flashing. Long press HEAD ② Place the drone on a flat and level surface with the head forward and the tail facing towards the pilot. ③ Short press the power switch button on the transmitter to turn it on, and you will hear a “Di” sound, then the indicator lights on the transmitter will flash.
11.2 Calibrating the Gyro Long press Long press the button on the transmitter to calibrate the gyro. The indicator lights on the drone will blink, then turn solid, and the transmitter will send out a long “Di” sound, which indicates that the calibration is Tip: To ensure a stable flight, we suggest that the pilot calibrates the gyro every time after pairing the drone and after a crash. ----------------------------------------------------------11.
11.4 One Key Takeoff/Landing Please unlock the motors before takeoff. ① Short press the One Key Takeoff/Landing button, the drone will take off automatically and hover at 4 feet. Now you can control this drone by using the joysticks. ② When the drone is flying, short press the same button again, the drone will automatically land on the ground. ----------------------------------------------------------12.0 FUNCTION DETAILS 12.1 Speed Switch This drone comes with 3 speed modes (Low/Medium/High).
12.2 Trimmer F/B Sideways Drift Trim: If the drone tends to drift forward, press down the Trimmer button and do not release it while pushing the right joystick down to re-balance the drone. If the drone tends to drift backward, press down the Trimmer button and do not release it while pushing the right joystick up to re-balance the drone.
12.3 Emergency Stop The Emergency Stop function should only be used in an emergency during the flight to avoid any damage or injury. Long press Long press Long press the upper left and upper right buttons of the transmitter at the same time. The motors will stop immediately. Attention: Be aware that you risk breakage of the drone if it falls from a large distance or hits anything at a high rate of speed. ----------------------------------------------------------12.
12.5 Take Photo/Record Video Take Photo: Short press the Take Photo/Record Video button, the transmitter sends out one beep, which indicates that the camera has taken one photo successfully. Record Video: Long press the Video button on the transmitter. You will hear two beeps which means the recording has started. Long press again to exit the recording, and you will hear a long beep from the transmitter. ----------------------------------------------------------12.
12.7 High-Speed Rotation During the flight, short press the High-Speed Rotation button, the transmitter will make a “Di” sound, which indicates that the drone enters the High-Speed Rotation function. The drone will exit the High-Speed Rotation function automatically after 10 seconds, or you can also push the right joystick in any direction to stop the rotation. -----------------------------------------------------------12.
12.9 Headless Mode Please familiarize yourself with the Headless Mode function first before using this mode. Otherwise, it is easy to lose the drone and cause unnecessary loss. HEAD TAIL 1. Short press the Headless Mode button on the transmitter. In Headless Mode, the indicator lights of the drone will keep on flashing, and the transmitter will constantly beep. 2.
HEAD HEAD TAIL TAIL HEAD TAIL Please make the pilot stays facing the same direction that the drone head faces at takeoff. While in Headless Mode, pushing the right joystick forward will make it fly in the direction that the head of the drone faces when it takes off. To make sure the pilot can tell the drone's direction during the flight, we recommend that pilot stays facing the same direction that the drone head faces at takeoff.
13.0 SPECIFICATIONS DRONE Model: D60 Weight: 166g/5.86oz Max Flight Time: 22 minutes (per battery) Operating Temperature Range: 32° to 104°F (0° to 40°C) Size: 332*234*60 mm (Unfolded) 145*81*60mm (Folded) ----------------------------------------------------------DRONE BATTERY Capacity: 1900mAh Voltage: 3.8V Energy: 7.
CAMERA Operating Frequency: 2412-2472MHz Photo Resolution: HD1920×1080P Video Resolution: HD1280×720P@25 fps Lens: FOV 60° Controllable Range: -90° to 0° Transmission Distance Range: 197feet/60m (outdoors and unobstructed) Photo Formats: JPEG Video Formats: AVI/MP4 Operating Temperature Range: 32° to 104°F (0° to 40°C) ----------------------------------------------------------USB CHARGING CABLE Input: 5 V/1A Rated Power: ≤5W -25-
14.0 CONTACT US Please do not hesitate to contact us if you need further support. 4:00 PM ~ 7:00 AM (PST) usa@deerc.com (USA) jp@deerc.com (JP) eu@deerc.com (EU) +1(855)777-8866 For online support, please scan this code with Live Chat.
15.0 GENERAL INFORMATION FCC Notice: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The Supplier's Declaration of Conformity is available at the following address: https://www.deerc.com/Download/US/D60_FCC_sDoC.pdf.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with minimum distance 20cm between the radiator & your body. This part belongs to the drone. RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement.
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. CAN NMB-3 (B) RF Exposure Radiation Exposure Statement: The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance. The minimum distance from body to use the device is 20cm.
< Haftungsausschluss & Warnung > BATTERY WARNING: 1. Failure to follow all the instructions may result in serious injury, irreparable damage to the battery and may cause a fire, smoke or explosion. 2. Always check the battery’s condition before charging or using it. 3. Replace the battery if it has been dropped, or in case of odor, overheating, discoloration, deformation or leakage. 4. Never use anything other than the approval LiPo charger the battery.
11. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are only to be charged under adult supervision. 12. Different types of batteries or new and used batteries are not to be mixed. 13. Batteries are to be inserted with the correct polarity. 14. The supply terminals are not to be short-circuited. Regular examination of transformer or battery charger for any damage to their cord, plug, enclosure and other parts and they must not be used until the damage has been repaired. 15.
We, Xiamen Huoshiquan Import & Export CO.,LTD hereby, declare that the compliance of the essential requirements with the Directive 2014/53/EU, the RoHS Directive 2011/65/EU and Safety Directive 2009/48/EC have been fully fulfilled on our product with indication below: Product Name: Remote control four axis series Model/Mark : D60/DEERC The Statement of compliance is available at the following address: http://www.deerc.com/Download/CE/D60_EU_DOC.pdf This product can be used among EU member states.
