Instructions

P a g e | 1 www.holybro.com

#15009

Spec：

Power Module Rated current:60A

Power Module Max current:120A(<60S)

UBEC output Current: 3A Max

UBEC Input Voltage: 7~42V（10S LiPo）

UBEC maximum power consumption: 18W

Power output: DC 5.1V~5.3V

Dimensions: 35x35x5mm

Mounting hole: 30.5mm*30.5mm

Weight: 24g

PIN MAP

PAGE 1
#15009 Spec： Power Module Rated current:60A Power Module Max current:120A(<60S) UBEC output Current: 3A Max UBEC Input Voltage: 7~42V（10S LiPo） UBEC maximum power consumption: 18W Power output: DC 5.1V~5.3V Dimensions: 35x35x5mm Mounting hole: 30.5mm*30.5mm Weight: 24g PIN MAP Page | 1 www.holybro.
PAGE 2
Make the PM06 show the quantity of electric charge of your battery Mission Planner setup: 1. Connect PM06 to the battery, also connect it to Mission Planner via USB. 2. Click “INITIAL SETUP” and come to the menu “Battery Monitor”. 3. Make “Monito” into “Analog Voltage and Current”. 4. Make “Sensor” into “9: Holybro Pixhawk4 PM”. 5. Make “HW Ver: "The Cube or Pixhawk" （pixhawk4,pixhawk4mini,pix32v5,pix32）” ※ “HW Ver: Durandal（Durandal）” ※ 6. Input “18.182” into Voltage divider (Calced). 7. Input “36.
PAGE 3
The XT60 plug and 12AWG wire that PM06 comes with is rated for 30A continuous current and 60A instantaneous current (<1 minute). If a higher current is being used, the plug type and wire size should be changed accordingly.