User manual

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 39
HOB 260ECO(LL)
13.5.2 Planing with tilted angle stop
 Loosen angle locking (A)
 Lay the workpiece on the planer table and press it to the
angle stop and the planer table
 The loosen angle stop moves to the required position
 Fix the angle stop in correct position
 Set the blade cover to a position that the blade shaft will
be covered
 Adjust the blade cover to let a space of 5mm to the
workpiece
 Lay the workpiece to the planer table and press it with one
hand to the angle stop
 Slide the workpiece with the other hand evenly over the
blade shaft.
13.5.3 Planing of short workpieces
 At planing short workpieces a push stick has to be used!
 Adjust the angle stop and blade cover to the size of the
push stick
 Slide the workpiece with the push stick evenly over the
blade shaft
13.5.4 Planing of workpieces with small cross-section
 At planing workpieces with small cross-section is it
necessary to mount a wooden assistant stop!
 Mount the wooden assistant stop with clamps like shown
on the right picture
 Lay the workpiece to the planer table and press it with one
hand to the wooden assistant stop
 Slide the workpiece with the other hand evenly over the
blade shaft