User manual

SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 18
USG 950
9.3 Security Instructions
Missing or non-readable security stickers have to be replaced immediately!
To avoid malfunction, damage and physical injury MUST be observed:
Use personal safety equipment: The wearing of safety glasses is mandatory
Always disconnect the machine prior to any actions performed at the machine.
 The drill bit sharpening device is not suitable for continuous use. If the engine is too hot, it
switches from thermally conditioned. The device is switched off, let them cool.
 When it comes to grinding sparks. Hold the drill sharpener at a safe distance from
flammable liquids and materials.
 Avoid touching the grinding stone and the workpiece immediately after use because they
are very hot.
 The workpiece during grinding turns blue, it may overheat and suffer damage. Cool the
workpiece during grinding, optionally in regular water.
 The drill sharpener is designed for dry grinding and may come in contact with any liquids.
The machine does not require extensive maintenance.
Repairing shall be performed by trained professionals only.
Accesories:
Use only accesories recommended by HOLZMANN-Maschinen and its sales partners.
Residual risk factors
Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
 Hearing, unless arrangements have been made by the user for hearing protection.
These risks can be minimized if all safety rules are applied, the machine is properly maintained and
serviced the machine as intended and is serviced by a trained service professional.
Despite all the safety devices and remains her good common sense and your appropriate technical
qualification / training on the operation of a machine such as the BSG 13E of the most important
safety factor!