User manual

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 20
USG 950
Terminal switch (2) Slowly release
lightly turning the drill end and
thereby pinch clamp springs in drill
nut.
The drill is perfectly set up as shown
in Fig. D.
 Press and hold to stop plate drill
and tighten with fixing grip
clockwise.
 Chuck guide while pressing the
clamp button (2) of the adjustment
(10) pull out.
E
drill tip pressed
Fig. D
Fig. E
Rotate the drill make sure the claw position
is the minmum width of the drill.
fixing grip