User manual

OPERATION

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 21

USG 950

 Insert chuck in relief angle grinding guide (3). Properly

set rotation restriction ribs lead. Figure H

 Turn the chuck in the clearance angle guide to the left

and right up and down until no sanding with grinding

sound more audible.

 Pull the chuck from the clearance angle guide and

rotate it through 180 °. Place the chuck back on and

try again.

 Turn off the sharpener on the ON / OFF switch.

 Let the wheel come to a standstill before removing the

chuck.

 Pull the chuck out of the guide and open the mount

Grip the chuck. Remove the finish-ground drill.

10.2 Grind drill

10.3 Grind drill clearance angle

INFO: Grind clearance angle is only suitable for drills over Ø 10mm.

 Switch on the device with the ON switch (1).

 Remove the protective cover.

 Insert the chuck with drill right into the grind

guide (5).

WARNING: The two ribs of the chucks in

the adjustment grooves running!

The rib on the holder should fit in the slot

on the guide.

 Turn the chuck in the honing guide slightly to the left and

right up and down until no sanding with grinding sound more

is heard.

 Pull the chuck from the honing guide and rotate it through

180 °. Place the chuck again correctly and try again.

 Turn off the unit at the ON / OFF switch. Let the wheel come

to a standstill before removing the chuck

Fig. F

Fig. G

CAUTION: Insert the two rotary limiting ribs

in the two adjustment grooves

Fig. H