Standard Single Door & Double Door Hardware Installation Manual
SAFETY PRECAUTIONS WARNING! Power tools can cause serious damage if not professionally used. Safety gear must be worn before installation to prevent unexpected injuries. Pick an area free of hazardous condition before you start on the project. Please use tools and power tools responsibly any loss of control and accident deaths may occur due to abuse of tools. Please make sure all hardware is secured on to the door is sufficiently tight. Doors with loose hardware may result in unexpected serious injuries.
HARDWARE INCLUDED Different track length comes with different hardware quantity. Please be sure to check the hardware you should have before installation. Hanger/Roller Box contains: Steel Hanger/Roller (2) Flat Track Track Measurement 4FT 4.5FT 5FT 5.5FT 6FT 6.6FT 7FT 7.
TYPE OF HANGERS 1 5/8’’ 1 5/8’’ 1 5/8’’ 1 5/8’’ Classic Straight 1 5/8’’ Star Arrow 1 5/8’’ Gear 1 5/8’’ Imperial Anchor Flame 1 5/8’’ Bucks 1 1/8’’ 1 5/8’’ 1 5/8’’ Twig 1 5/16’’ Diamond 1 5/8’’ Mustache 1 5/8’’ Royal 3 1/2’’ Horns 1 1/4’’ 3 11/16’’ Horseshoe Black Wheel T-shape www.homacer.
INSTRUCTIONS Draw a horizontal line using the following formula (1/2” + Door Height + 1 1/2”). This line will be used to line up horizontally to the center of the track. Door Height REMINDER: Make sure your floor is level. If not, please measure the distance from the highest point of your floor. This procedure should be done so that when the doors go on the track it will slide smoothly above that highest point of the floor.
Open a slot that is 1/4” wide and 13/16” deep at the bottom of the door with a routher. This groove will be used with the floor guide. Step- Drill the holes for the hanger according to the dimension given in the picture.The distance between the top edge of the door and the center of the upper hole is 1 5/8”. The distance between the side edge of the door and the hanger is up to your choice. It should be at least be a minimum of 1” away from the edge to prevent any damage to your doors.
To mount your doors onto the track, you will have to lift your door at a slight angle and rest both wheel grooves onto the top of the track carefully. Step - 7 Usually floor guides are installed corner of the opening for standard single and double door hardware but we recommend to install the regular floor guide in your own location preference depending on how you want your inside door to slide.
SLIDING HARDWARE / BARN DOORS High Quality Exquisite Design Outstanding Services ABOUT US At Homacer, our goal is to provide the finest sliding barn door hardware products and services for our valued customers. We keep polishing our products to make their quality better, prices lower and installation easier. We make it possible for you to get everything you need from us when you think about installing sliding barn doors. CONTACT US Office #: 1(770) 864-5437 Website: www.homacer.