Single Track Bypass Barn Door Hardware Installation Manual
SAFE TY PRECAUTIONS WARNING! Power tools can cause serious damage if not professionally used. Safety gear must be worn before installation to prevent unexpected injuries. Pick an area free of hazardous condition before you start on the project. Please use tools and power tools responsibly any loss of control and accident deaths may occur due to abuse of tools. Please make sure all hardware is secured on to the door is sufficiently tight. Doors with loose hardware may result in unexpected serious injuries.
HARDWARE INCLUDED Different track length comes with different hardware quantity. Please be sure to check the hardware you should have before installation. contains: Hex Bolt (4), Acorn Nut (4), Washer (8) Anti-Jump Pad (2), Floor Guide (1) Door Stopper (2), Hex Wrench (1) contains: Bent L Shape Adjustable Spacer, Lag Bolt, and Washer Set Track Measurement 4FT 4.5FT 5FT 5.5FT 6FT 6.6FT 7FT 7.5FT 8.
INSTRUCTIONS Draw a horizontal line using the following formula (1/2” + Door Height + 1 1/2”). This line will be used to line up horizontally to the center of the track. Door Height REMINDER: Make sure your floor is level. If not, please measure the distance from the highest point of your floor. This procedure should be done so that when the doors go on the track it will slide smoothly above that highest point of the floor.
Open a slot that is 1/4” wide and 13/16” deep at the bottom of the door with a router. This groove will be used with the floor guide. Classic Design Hanger Straight Design Hanger Drill the holes for the hanger according to the dimension given in the picture. This distance from the top of the door to the center of the upper hole is 1 5/8”. The distance from the left (right) edge of the door to the left (right) edge of the hanger is up to your choice.
Install the anti-jump pads on top of the door as shown in the picture. There is no strict requirement on its position. - To mount your doors onto the track, you will have to lift your door at a slight angle and rest both wheel grooves onto the top of the track carefully. Usually floor guides are installed in the middle of the opening for single track bypass but we recommend to install the regular floor guide in your own location preference depending on how you want your inside door to slide.
Classic Design Hanger Straight Design Hanger Repeat the same step for the bent hanger design. Just like step 5. Please follow the diagram above on how the hex bolt, washers and nut should be installed on the door and hangers. Do not install them any other way since it may interfere with the function of the sliding system. 10 INSTALLATION OF THE ADJUSTABLE FLOOR GUIDE FOR BENT HANGERS Install the bypass floor guide on to the area marked. Put the hardware together.
SLIDING HARDWARE / BARN DOORS High Quality Exquisite Design Outstanding Services ABOUT US At Homacer, our goal is to provide the finest sliding barn door hardware products and services for our valued customers. We keep polishing our products to make their quality better, prices lower and installation easier. We make it possible for you to get everything you need from us when you think about installing sliding barn doors. CONTACT US Office #: 1(770) 864-5437 Website: www.homacer.
