MSDS

ManualsBrandsHomax ManualsPaint1-gal. Wet-look Cure Seal for Concrete

1. PRODUCT IDENTIFICATION

TRADE NAME (AS LABELED): Homax Gloss Wet Look Cure Seal

PRODUCT CODE: 0613

PRODUCT USE: Concrete curing compound/sealer

SUPPLIER/MANUFACTURER'S NAME: HOMAX PRODUCTS, Inc.

ADDRESS: 200 Westerly Rd.

Bellingham, WA 98226

BUSINESS PHONE: 1-800-729-9029

CHEMTREC EMERGENCY NO.: 1-800-424-9300 (United States)

1-703-527-3887 (International Collect)

DATE OF PREPARATION: May 25, 2010

2. COMPOSITION and INFORMATION ON INGREDIENTS

CHEMICAL

NAME

CAS # % w/w EXPOSURE LIMITS IN AIR

ACGIH-TLV OSHA-PEL NIOSH-REL

TWA STEL TWA STEL TWA STEL IDLH

ppm ppm ppm ppm ppm ppm ppm

Acrylic Polymer Unknown 10-20 N/A N/A N/A N/A N/A N/A N/A

Water and ingredients present in

concentrations of less than 1%(or

less than 0.1% if carcinogens)

Balance The ingredients in the balance of this product do not contribute significant

hazards beyond those described in this document. All pertinent health, safety and

environmental information has been presented, per the requirements of the US

Federal OSHA Hazard Communication Standard (29 CFR 1910.1200) and

Canadian WHMIS.

NE = Not Established. See Section 16 for Definitions of Terms Used.

NOTE (1): ALL WHMIS required information is included in appropriate sections based on the ANSI Z400.1-1998 format. This product has been classified in

accordance with the hazard criteria of the CPR and the MSDS contains all the information required by the CPR.

3. HAZARD IDENTIFICATION

EMERGENCY OVERVIEW:

PHYSICAL DESCRIPTION: This product is a milky white liquid.

HEALTH HAZARD: This product may cause irritation to the eyes or skin. If high concentrations of vapors or mists are inhaled,

irritation of the nose, throat or respiratory tract may occur. Ingestion may cause gastrointestinal irritation, nausea, diarrhea.

FIRE HAZARD: No significant hazard.

REACTIVITY HAZARD: The product is stable under ordinary conditions.

ENVIRONMENTAL HAZARD: This product does not present a significant hazard to terrestrial and aquatic life.

SYMPTOMS OF OVEREXPOSURE BY ROUTE OF EXPOSURE:

The most significant routes of occupational overexposure are contact with skin and eyes. The symptoms of overexposure to this

product are as follows

INHALATION: Non hazardous in the case of inhalation. Mists or sprays of this product may cause irritation of the mucous

membrane of the nose, throat, and respiratory tract.

CONTACT WITH SKIN or EYES: Direct contact may cause slight eye or skin irritation.

SKIN ABSORPTION: This product is not reported to be absorbed through the skin.

Page 1 of 6

Summary of content (6 pages)

PAGE 1
. PRODUCT IDENTIFICATION TRADE NAME (AS LABELED): PRODUCT CODE: PRODUCT USE: SUPPLIER/MANUFACTURER'S NAME: ADDRESS: BUSINESS PHONE: CHEMTREC EMERGENCY NO.: DATE OF PREPARATION: Homax Gloss Wet Look Cure Seal 0613 Concrete curing compound/sealer HOMAX PRODUCTS, Inc. 200 Westerly Rd. Bellingham, WA 98226 1-800-729-9029 1-800-424-9300 (United States) 1-703-527-3887 (International Collect) May 25, 2010 2.
PAGE 2
INGESTION: diarrhea. Ingestion is not anticipated to be a significant route of exposure. May cause gastrointestinal irritation, nausea, Hazardous Materials Identification System (HMIS) Health 1 Flammability 0 Physical Hazard 0 Protective Equipment B See Section 16 for Definition of Ratings HEALTH EFFECTS OR RISKS FROM EXPOSURE: An Explanation in Lay Terms. ACUTE: Depending on the duration of contact, overexposures may irritate the eyes, skin, mucous membranes, and any other exposed tissue.
PAGE 3
UNUSUAL FIRE AND EXPLOSION HAZARDS: When involved in a fire, this material may decompose and produce irritating fumes and toxic gases (e.g., carbon monoxide, carbon dioxide). Explosion Sensitivity to Mechanical Impact: Not sensitive under normal conditions. Explosion Sensitivity to Static Discharge: Not sensitive under normal conditions. SPECIAL FIRE-FIGHTING PROCEDURES: Incipient fire responders should wear eye protection.
PAGE 4
protection is not normally needed. Use body protection appropriate for task (e.g., Tyvek suit, rubber apron). If a hazard of injury to the feet exists due to falling objects, rolling objects, where objects may pierce the soles of the feet or where employee’s feet may be exposed to electrical hazards, use foot protection, as described in U.S. OSHA 29 CFR 1910.136. HMIS PERSONAL PROTECTIVE EQUIPMENT RATING: Industrial Use situations: B; Safety Glasses and Gloves. 9.
PAGE 5
ENVIRONMENTAL STABILITY:. The following environmental data is available for components of his product: No data available. EFFECT OF MATERIAL ON PLANTS or ANIMALS: This product is not anticipated to cause significant effects on terrestrial plants or animal if released in small, consumer-sized volumes. The product may be harmful if large volumes of it are released into the environment.
PAGE 6
Disclaimer: As the handling and use of products under user’s conditions are beyond our control, no warranty, expressed or implied, including, but not limited to merchantability or fitness for a particular use, is made concerning this product. The user assumes all risk of use or handling whether or not in accordance with any directions or suggestions of the supplier.