Use & Care Guide

SEE ONLINE DEMO at www.homaxproducts.com/texture
Homax
®
A Premier Brand of
The Homax Group, Inc.
Bellingham WA 98227
www.homaxproducts.com
800-729-9029
MADE IN USA
4099 122010
Flat Paint Product VOC < 60% MIR <1.20
This product is covered by one or more U.S. Patents.
Steel Dome Print:
READ DIRECTIONS
FOR BEST RESULTS
SPRAY SHORT BURSTS
MATERIAL DISCHARGES RAPIDLY
DANGER! FLAMMABLE VAPOR. CONTENTS UNDER
PRESSURE. CAUSES EYE, SKIN AND RESPIRATORY TRACT
IRRITATION. Contains Calcium Carbonate, Clay, Perlite,
Titanium Dioxide and Dimethyl Ether (propellant). Vapors may
catch fire. Keep away from heat, sparks and flame. Extinguish
all flames and sources of ignition during use and until all vapors
are gone. Prevent build-up of vapors by opening all windows
and doors to achieve cross-ventilation. Store upright in a cool,
dry place. Avoid prolonged exposure to sunlight and other heat
sources that may cause bursting. Do not puncture, incinerate,
burn or store above 120°F. Use with adequate ventilation. Avoid
breathing vapor and spray mist. Avoid contact with eyes and
skin. Wear safety glasses or goggles. Wash hands after using.
FIRST AID: For eye contact, flush thoroughly with water for 15
minutes and get medical attention. For skin contact, wash
thoroughly with soap and water. If inhaled, remove person to
fresh air. If breathing does not improve, get medical attention.
KEEP OUT OF THE REACH OF CHILDREN.
WARNING: This product contains a chemical known to the
State of California to cause cancer. WARNING: If you
scrape, sand or remove old paint, you may release lead
dust. LEAD IS TOXIC. Contact the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead. ASBESTOS WARNING: If your ceiling
texture was applied prior to 1979, DO NOT attempt to
remove it without having it tested for asbestos content.
Contact your local EPA office or log on to
www.epa.gov/asbestos for information.
Steel Dome Print
EXAMPLE:
More Coverage*
Vertical Spray
Easy Patch
Easy Patch
POPCORN
6 sq. ft.
0,56 m²
WATER BASED
Más cobertura*
Rocío vertical
Net Wt 14 OZ
(396 g)
Reparación
sencilla
Cáscara de
naranja
Homax
®
Easy Patch Ceiling Texture contains
chip material that replicates popcorn, perlite or
aggregate-type ceiling textures. Use to patch
and repair damaged ceiling texture, or apply
new texture to small areas.
PROTECT CARPET, FURNITURE AND WALLS
FROM OVERSPRAY.
Water-based, use warm water for clean up.
• Sprays best between 68˚ F and 72˚ F.
• Eye protection recommended.
• DO NOT spray sideways or upside down.
DIRECTIONS FOR USE: MAKE ANY NECESSARY
CEILING REPAIRS BEFORE APPLYING.
PRIME/SEAL AREA WHITE BEFORE APPLYING
TEXTURE.
1. Shake can vigorously for one minute.
2. Screw nozzle onto valve stem.
3.
Place fingers on either side of the
spray nozzle and hold approximately
9-14” from ceiling surface.
4. To spray, quickly trigger nozzle in
half second bursts, releasing the
nozzle after each pass. Use short,
sweeping strokes, feathering
texture into surrounding area. If
nozzle is held down continuously,
propellant will be released in 2 to 4
second leaving unused material in
can. Proper technique allows for 8
to 10 short application strokes.
DRY TIME: Allow texture to dry 24
hours if painting over is desired.
TIP: For a heavier “chip” appearance
apply in multiple thin coats, allowing
texture to dry slightly between
applications.
TIP: Do not apply too heavily or
texture will drip or sag.
*
More coverage than Homax® Pro Grade Ceiling Texture.
El restaurador de fácil aplicación para texturas de
techo Homax
®
contiene material en fragmentos que
reproduce acabados de techo muy rugosos, de
perlita o de tipo agregado. Úselo para reparar y
cubrir acabados para techos dañados o para aplicar
nuevo acabado sobre áreas pequeñas.
PROTEJA LAS ALFOMBRAS, MUEBLES Y PAREDES DEL
EXCESO DE CHORRO.
CONSEJO: Coloque una cortina de plástico o sostenga
una caja alrededor de la zona que se va a cubrir para
que retenga el exceso de chorro.
• La textura es a base de agua, utilice agua tibia para
lalimpieza.
• Se rocía mejor entre 20 °C y 22,2 °C.
• Se recomienda el uso de lentes de protección.
• NO rocíe hacia los costados ni de arriba abajo.
INSTRUCCIONES DE USO: ANTES DE LA APLICACIÓN,
REPARE EL TECHO SEGÚN SEA NECESARIO. APLIQUE
PINTURA BASE O SELLE EL ÁREA DE BLANCO ANTES DE
APLICAR LA TEXTURA.
1. Agite la lata vigorosamente durante un minuto.
2. Enrosque la boquilla en el vástago de la válvula.
3. Coloque los dedos en uno de los lados de la
boquilla del chorro y sosténgalo a una
distancia de entre 20,86 cm y 35,56 cm
aproximadamente de la superficie del techo.
4. P
ara que salga el chorro, presione rápidamente
la boquilla con toques de medio segundo y
suéltela después de cada pasada. Use
movimientos cortos y de barrido para a lisar la
textura en el área circundante. Si mantiene
presionada la boquilla continuamente, el
propelente se saldrá en 2 a 4 segundos y dejará
el material sin usar dentro de la lata. Una técnica
adecuada permite de 8 a 10 movimientos cortos
de aplicación.
TIEMPO DE SECADO: Si desea pintar, deje que la
textura seque durante 24 horas.
CONSEJO: Para un acabado aún más rugoso,
aplique muchas capas gruesas y deje que el
acabado seque ligeramente entre cada
aplicación.
CONSEJO: No aplique demasiado o el acabado
goteará o se doblará.
*Más cobertura que la textura para cielos rasos Homax® Pro Grade.
Para leer todas las advertencias en español,
visite www.homaxproducts.com
Textura
para techo
Ceiling
Texture
Ceiling
Texture
Ceiling
Texture
REPAIR
DRAPE
ATTACH
SPRAY
DANGER! FLAMMABLE VAPOR. CONTENTS UNDER PRESSURE.
CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION.
Read other cautions on side/back panel before using.
¡PELIGRO! CONTENIDO BAJO PRESIÓN. CAUSA IRRITACIÓN EN
LOS OJOS, LA PIEL Y LAS VÍAS RESPIRATORIAS.
Lea otras precauciones en el panel posterior y lateral antes de usar.

Summary of content (1 pages)