INcjh039_US 824-031V80 IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY ASSEMBLY & INSTRUCTION MANUAL
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND.OTHER BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! IMPORTANT SAFETY INFORMATION 1. Read all instructions carefully before using the FAN. 2. Use this FAN only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. 3.
13. Disconnect the fan from the mains power when not in use, and before servicing or performing any maintenance. 14. This appliance can be used by children aged from 8 years and above and persons with reduced physical,sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
PARTS NAME ASSEMBLY 1. Snap the two parts of the base together and secure with the four screws using a screwdriver. 2. Line up the Tower fan on the base. Fix with the 4 screws, with a screwdriver. shown in FIGURE 1.
REMOTE CONTROL 1. lnstall one ‘mercury’ (not included) batteries. The Remote Control Power button is labeled as such. All the functions performed with the Remote Control work identically to the Manual Controls. ( FIGURE 2). FIGURE 2 OPERATION The FAN may be operated by the manual controls located on the FAN (as shown in FIGURE 3) or by your remote control (shown in FIGURE 2 ) . FIGURE 3 1. Place the FAN on a stable flat surface. Plug the cord set into a 120V~AC electrical outlet.
POWER: Turn the FAN on by pressing the ‘ ’ button; Turn the ’ button again. FAN off by touching the ‘ SPEED: You can adjust the fan speed to the desired level: low, medium, or high by touching ’ ’ . The speed setting is displayed on the FND screen(shown in FIGURE 4) .. ’ MODE: Touching the ’ button will set the FAN into NORMAL, NATURAL, and SLEEP mode . TIMER: The fan is equipped with a timer that allows you to set it's length of operation from 1 hour to 12 hours. Pressing the ’ ’ button.
FIGURE 4 Filter installation 1. Insert the filter to the grid. 2. Fix it by 2 screws. See FIGURE 5 FIGURE 5 MAINTENANCE 1. This can only be done by an authorized service agent such as your local Sealer dealer or any agent qualified to undertake electrical repairs.
2.If the unit requires external cleaning make sure it is switched off and unplugged from the mains supply. Use a soft tissue or cloth for general cleaning. To remove more persistent dirt or grime wipe down with a cloth that has been dampened with warm soapy water. Do not use any solvents ( such as thinners ) as these may damage the plastic casing.
