INcjh017_US 824-049V80 TOWER FAN 120V~60Hz 45W READ AND SAVE THIS INSTRUCTION FOR FUTURE USE ASSEMBLY INSTRUCTION
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND.OTHER BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! IMPORTANT SAFETY INFORMATION 1. Read all instructions carefully before using the FAN. 2. Use this FAN only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. 3.
WARNING : The Main Power Switch and the On/Off switch should not be used as the sole means of disconnecting power. Always unplug the power cord before servicing or moving the unit. 14. Always disconnect the fan from the power supply when moving it from one location to another. 15. Keep the fan clean and maintain in good condition (use an authorized service agent). 16. Use recommended parts only (non genuine parts may be dangerous, and will invalidate your warranty). 17.
PARTS NAME ASSEMBLY The base of the tower fan comes in two parts, which fit around the oscillation base. Both parts fit easily together. The back half is the one with cut-outs for the power supply cord. 1. First attach the front half of the base, aligning the holes in base with the screw holes in the oscillation base, and leading the power cord through the centre hole. 2.
(Figure 1) 3. Thread the power supply cord through the two cut-outs at the bottom of the base. REMOTE CONTROL 1. Included a button cell battery (the type of battery CR2025). The Remote Control Power button is labeled as such. All the functions performed with the Remote Control work identically to the Manual Controls. (FIGURE2) 824-049V80 OPERATION The FAN may be operated by the manual controls located on the FAN (as shown in FIGURE 3) or by your remote control (shown in FIGURE 2).
(FIGURE 3) 1. Place the FAN on a stable flat surface. Plug the cord set into a 220-240V~A.C. electrical outlet. 2. POWER: Turn the FAN on by pressing the ‘POWER’ button; Turn the FAN off by pressing the ‘POWER’ button again. 3. SPEED: You can adjust the fan speed to the desired level: low, medium, or high by pressing ’SPEED’. The speed setting is displayed on the LED screen (shown in FIGURE 4). 4. MODE: Pressing the’ MODE’ button will set the FAN into NORMAL, NATURAL, and SLEEP mode. 5.
9.DISPLAY LED- can be switched off temporarily by pressing the DISPLAY button on the remote control or by pressing and holding the SPEED button on the control panel from more than 3 seconds,the display will light up again once any control button is activated. 824-049V80 FIGURE 4 MAINTENANCE 1. This can only be done by an authorized service agent such as your local Sealer dealer or any agent qualified to undertake electrical repairs. 2.
