Instructions / Assembly

Fire Pit
Assembly Instructions
853225
STEP 1
STEP 3
STEP 2
Want To Give Your New Fire Pit That Aged, Rich, Rusty Patina? Here’s How!
Ingredients:
• 16 oz. Hydrogen Peroxide (Use Fresh Bottle for best results)
• 2 oz White Vinegar
• ½ Tbsp Salt
Use rubber gloves and safety goggles!
1. Mix the above ingredients in a clean spray bottle. Mix well to ensure the salt has fully dissolved.
2. Clean the re pit thoroughly (all sides) with a good degreaser to remove any oil or dirt from the surface. NOTE: This step is not necessary
but will give the best results. Allow the parts to dry completely.
3. You may assemble the re pit or for an even patina, lay each of the metal pieces on a at surface, then apply the solution to one side
at a time.
4. Apply your rst coat by lightly misting the solution over the entire surface of each part. Allow this coat to dry. You will see the rust begin
to form within the rst few minutes of application. Continue to apply the solution, allowing it to dry between applications until you have
achieved the desired patina.
5. Allowing the solution to puddle or run will give different patterns. Happy Rusting!
Other Finishing Options
• Painted- Paint using a high temperature grill paint in a well ventilated area.
• Raw- If no nish is desired, regularly applying a thin coat of cooking oil will reduce rusting.