Instructions / Assembly

Fig.3
Fig.2
Fig.1
Never allow any part of the set to contact with a source of heat or
flames.
Always position your tree and cable and any extension leads so that
they will not be a hazard to the elderly, pets and children.
Caution-Artificial trees have small parts which may pose a choking
hazard detached from the branches.
BEFORE YOU START
 Decide on appropriate location for your product.
 Remove all packaging and dispose of safety out of the reach of
children & animals.
 Please note, it is recommended that two people assemble this
item.
These instruction are for your proper use and your safety.
Pleas read them thoroughly before use and retain for future reference.
WARNING-FOR SAFETY
BULB REPLACEMENT INSTRUCTIONS
1. Unplug light string from power source.
2. Pull up on the Bulb Lock (if equipped) unlatching the bulb from the bulb
socket. Gently pull the bulb straight out(Figure 1).
3. Before inserting the new bulb into socket, make sure that the two wires on
either side of the the bulb base are straight up and flush with the base (diagram
at right).
4. Carefully insert new bulb into socket and push down Bulb Lock (if equipped)
until it snaps into place (Figure 2).
Fig.1
Fig.2
FUSE REPLACEMENT INSTRUCTIONS
1. Unplug light string from power source.
2. Fuses are located in light string plug. Slide the fuse access cover away from
cord side (in direction of arrow, Figure 1) exposing fuses.
3. Remove fuses from compartment and examine. Replace burnt out fuse with
new one.
4. Close fuse compartment by sliding access cover back in towards cord side of
plug (Figure 2).
Fig.1
Fig.2
SHAPING INSTRUCTIONS
Shaping the tree branches is the last
step of assembly. The care and
attention given to this final process
will result in a genuinely beautiful
and appealing holiday centerpiece.
1. Every tree style is shipped from
the factory with the tips of each
branch compressed to the center
(Figure 1).
2. Each branch tip must be shaped
to it's proper position to give the tree
a natural look. This is done by gently
grasping the left and right wing tips
and spreading them out away from
the center tip (Fi
gure 2).
3. Each individual tip should then be
spread out separately. Tips should
then be bent slightly upward to add a
more natural looking appearance.
Figure 3 shows a typical tree branch
after shaping.Branch tips should be
carefully pressed back toward center
tip when tree is disassembled for
storage in original carton.
SAVE THESE INSTRUCTIONS
HOW TO ASSEMBLE THE TREE
Each carton contains branch section, and a tree urn.
1. Remove trees and urns from packaging before beginning, keep
carton for future storage.
2. Select an area where the ground is firm enough to hold the tree
upright.
3. Put the urn on the ground then plug the tree bottom into to the urn,
4. Final step is branch shaping. All hinged branches should fall into
lowered position during assembly. Any branches that remain uprigh
t
should be gently lowered by hand. Please refer to Shaping Instructio
ns
for proper branch sha
ping technique.
6.5FT Sparkling Pine Potted Tree
SKU# ??????
Model#
16HD0165
INSTRUCTIONS MANUAL
Retain carton for
storage purposes.
and put tree middle section into bottom section, put tree top into middle section.