Instructions / Assembly

1 2
SET-UP AND OPERATING INSTRUCTIONS FOR THE
3 FT BLISSFUL FIGURES LED ROCKING HORSE
SKU#1006 215 482
INSTRUCTION MANUAL
READ CAREFULLY & RETAIN FOR FUTURE REFERENCE!
A. Head
X 1
X 1X 1
D. AC/DC Adapter E. Cable B. Body and Base
X 1
C.Tail
X 1
WARNING: This is not a toy and is for decorative purposes only. For outdoor covered use. This item is not intended for use by children under the
age of 14 years. Do not place product near an open fire or heat source such as a radiator, stove, etc.
Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-855-HDHOLIDAY
(1-855-434-6543), Mon-Fri 8am-7pm and Sat from 9am-6pm EST or email at [e-mail].
ASSEMBLY:
Part List
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: “(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.”
Responsible party for FCC: Pan Asian Creations Limited. Address: 2560 King Arthur Blvd, Suite 124-26, Lewisville, TX 75056.
For FCC assistance email: [e-mail]
SAFETY INSTRUCTIONS:
1. All cautions in these operating instructions should be followed completely.
2. Do not use near water; such as bathtub, laundry tub, kitchen sink, wet basement or swimming pool, etc.
3. Do not display figure near any heat source such as radiators, stoves, fireplaces, etc.
4. Display should be serviced by a qualified service person only. Do not attempt to service this unit beyond what is described in the operating instructions.
5. Take extra care when displaying any figure that may contain small parts around small children.
6. Use of this decoration should always be supervised by an adult.
7. Remove AC/DC adapter when not in use.
OPERATING INSTRUCTIONS:
1. Place the product on a water-resistant, level surface.
2. A UL Listed, 4.5Volt 670mA adapter is included with the product. The power adapter needs to be plugged into a standard 100V-240V household power outlet.
3. The ON/OFF switch is located under the body of the horse. Place the switch to the “ON” position to activate LED lights and the timer feature. When
activated, the timer feature will automatically turn the lights on for 6 hours and will shut off for 18 hours.
4. Place the switch into the “OFF” position and unplug the adapter when not in use.
A
C
B
Problem Solution
The product
does not work
3. Check to make sure the adapter is connected to a working power source. Make sure the
adapter is plugged into a standard 100V-240V household outlet.
1. Check all wire connections and make sure all parts are securely attached.
2. Check and make sure the ON/OFF switch is in the "ON" position.
TROUBLESHOOTING:
If you are still experiencing problems with the product, please call 1-855-HDHOLIDAY (1-855-434-6543) or email
[e-mail] for further assistance.
05202021_2008482
Printed in China
B
C
Step 1
Step 2
E
D
Once the cable has been
connected and secured
into the body and adapter,
plug the adapter into a
standard 100V-240V
household power outlet.
Once the power supply has
been plugged in, toggle the
ON/OFF switch located
under the body to the “ON”
position to activate LED
lights.
Connect one end of the cable (E) into the
connection located under the body, and then
connect the UL-Listed, 4.5V 670mA AC/DC Adapter
(D) into the connection at the opposite end of the
cable (E).