Instructions / Assembly

SET-UP AND OPERATING INSTRUCTIONS
FOR THE 4.5-FOOT LED FEEDING REINDEER
SKU#1006 215 485
INSTRUCTION MANUAL
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-527-0313, 8 a.m. to 5 p.m., EST, Monday-Friday or email at
[e-mail].
WARNING: This is not a toy and is for decorative purposes only. For indoor and outdoor use. This
item is not intended for use by children under the age of 14 years. Do not place product near an open
fire or heat source such as a radiator, stove, etc.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: “(1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.”
Responsible party for FCC: Pan Asian Creations Limited.
Address: 2560 King Arthur Blvd, Suite 124-26, Lewisville, TX 75056.
For FCC assistance email: [e-mail]
READ CAREFULLY & RETAIN FOR FUTURE REFERENCE!
SAFETY INSTRUCTIONS:
1. All cautions in these operating instructions should be followed completely.
2. Do not use near water; such as bathtub, laundry tub, kitchen sink, wet basement or swimming pool, etc.
3. Do not display figure near any heat source such as radiators, stoves, fireplaces, etc.
4. Display should be serviced by a qualified service person only. Do not attempt to service this unit beyond what
is described in the operating instructions.
5. Take extra care when displaying any figure that may contain small parts around small children.
6. Use of this decoration should always be supervised by an adult.
7. Remove AC/DC adapter when not in use.
05202021_2008485
Printed in China
1 2
3
4
5
6
PART LIST
A. Body B. Left front leg C. Right front leg
D. Left hind leg E. Right hind leg F. Head with Neck
G. AC/DC Adapter and Cable
X 1 X 1 X 1
X 1 X 1 X 1
X 1
Line up the two small tabs, Turn four
legs clockwise to lock in place.
ASSEMBLY:
C
C
D
D
A
A
E
F
A
E
B
B
Step 1
Step 2
Step 3
Step 4
F
A
Plug the adapter into
a standard 100V-240V
household outlet.
AC Adapter
(DC 4.5V, 670mA)
Problem Solution
The product
does not work
3. Check to make sure the adapter is connected to a working
power source. Make sure the adapter is plugged into a
standard 100V-240V household outlet.
1. Check all wire connections and make sure all parts are securely
attached.
2. Check and make sure the ON/OFF switch is in the "ON" position.
TROUBLESHOOTING:
OPERATING INSTRUCTIONS:
1. Place the Reindeer on a water-resistant, level surface.
2. A UL Listed, 4.5Volt 670mA adapter is included with the Reindeer. The power adapter
needs to be plugged into a standard 100V-240V household power outlet.
3. The ON/OFF switch is located under the abdomen of the Reindeer. Place the switch to
the “ON” position to activate LED lights and the timer feature. When activated, the
timer feature will automatically turn the lights on for 6 hours and will shut off for 18
hours. Place the Switch into the “OFF” position and unplug the adapter when not in use.
4. Unplug the power adapter when not in use.
If you are still experiencing problems with the product, please call
1-877-527-0313 or email [e-mail] for further assistance.
Small Tabs