Instructions / Assembly

Remove the Try-Me Button

Assembling the Witch Head and Controller to the

Stake

Remove the packing and take out the product carefully. Place all parts flat

on the ground. Disconnect the plug on the Try-Me Button (C) from the

controller .

Insert the non-pointed end of the Stake (D) into the connecting hole at the

bottom of each Witch Head (A) and the Controller (B) until firmly tight.

Note: Handle the handle Witch Head (A) with care while performing this

task.

3 Anchoring the Ground Stakes 4 Accessing Battery compartment on Controller

Insert the Ground Stakes (D) into the ground by grasping the Ground

Stake in the middle then firmly pushing into the ground. Note: Do not push

down on the top of the Witch Head. This could cause breakage. Hint: If

the ground is hard use water to moisten the ground for an easier install.

Loosen the screws on the cover on the back side of the Controller (B).

Remove the back cover of the Controller away from the body of the

Controller.

5 Installing and Replacing the Batteries 6

Securing the Battery compartment cover on

Controller

Fit the batteries, requires 3 AA Batteries (sold separately), one after

another, into the Battery Compartment of the Controller. Make sure the

Batteries are placed in the correct direction with the polarity matching

what is indicated on the inside of the Battery box.

Place the cover on the back side of the Controller. Place the screws into

the screw holes and tighten firmly taking care not to strip the threads.

7 Operating the Controller

On the back side of the Speaker is a power switch. Move the switch to

ON. This will activate the built in sound sensor. When the sound sensor is

activated the speaker will play phrases and the Witches mouths will

move.

ASSEMBLY