Instructions / Assembly

PLEASE RETAIN THIS INFORMATION FOR YOUR FUTURE REFERENCE
OPERATING INSTRUCTION:
Insert (3) AA batteries, sold separately, into battery compartment on back of unit.
It contains Constant ON / OFF / TIMER switch. Slide switch to ON” position to have constant LED lighted up. Slide switch to “OFF” position to turn
off. Slide switch to “TIMER” position to have timer function.
The TRY-ME feature is intended for in-store demonstration only.
Please remove TRY-ME wire and insert batteries into battery compartment during normal operation.
Remove battery if the product is to be left unused for a long period of time.
BATTERY INSTALLATION:
Locate battery compartment on back of unit.
Remove compartment door using a small Phillips-head screwdriver, sold separately.
Place (3) new AA batteries, sold separately, into the compartment, matching the polarity of the batteries to the markings
in the compartment.
Replace battery compartment door and hand tighten screw to hold door in place.
TIMER
This item contains a timer. When the switch is switching to the “TIMER” position, the item will light up and glow for 6 hours, then automatically go off.
The next day it will come on at the same time. It is 6 hours on and 18 hours off. Cancel the timer by sliding the switch to the OFF position, or sliding the
switch to the ON position to keep the LED lighted on.
CAUTION:
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium, ni-mh etc.) batteries.
Do not mix old and new batteries. Replace all batteries of a set at the same time.
Clean both ends of the battery contacts and the contacts of the device prior to installing the batteries.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment that is not to be used for an extended period of time.
Remove used batteries promptly.
Batteries should only be changed under adult supervision.
Do not dispose of batteries in fire. Batteries may explode or leak.
Exhausted batteries are to be removed from the product.
Batteries are harmful if swallowed. Keep away from young children.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Summary of content (1 pages)