Instructions / Assembly
NOTE: DO NOT USE A DIMMER SWITCH OR INSTALL ANY
ADDITIONAL CHRISTMAS LIGHTING OR ORNAMENTATION
THAT IS POWERED BY A LIGHT BULB SOCKET. DOING THIS
MAY RESULT IN DAMAGE TO THIS PRODUCT OR CAUSE
PERSONAL INJURY. THIS ACTION WILL RESULT IN A VOID
OF THE LIMITED WARRANTY OF THIS PRODUCT.
1. Failure to light; unplug the product and check to see that
the GFCI outlet is functioning.
2. A section fails to light; unplug the product and check all
light string connections. This product uses low voltage
coaxial connections. To connect the light strings; align the
male end to the female connectors as shown and connect
them together. Slide the screw cover from the “male”
connector over the “female” connector and tighten (Fig 6).
TROUBLESHOOTING
1. Leave assembled if storage room permits or disassemble,
placing all components in the original carton.
2. Store in cool, dry location away from sunlight.
CARE AND CLEANING
Model No. 7407158UHO
Made in China
Printed in China
This is not a toy, for decorative use only.
This product was pre-tested before shipment and date
coded. In keeping with the National Electric Code, this
product is intended for seasonal (90 days max.) installation
and use. For problems or questions on this product call
Home Depot customer service toll-free at 1-877-527-0313.
DISTRIBUTED BY HOME DEPOT U.S.A., INC. 2455
PACES FERRY RD., N.W. Atlanta, GA 30339 All rights reserved.
LED14
This outdoor bow sculpture includes replacement bulbs
for any replacements that you need to perform on your
sculpture. If extra parts are needed, contact the Customer
Service Team at 1-877-527-0313.
MAINTENANCE
2. Fully layout the three bow sections to form a bow (Fig 2).
ASSEMBLY INSTRUCTIONS:
No tools required.
Retain carton for storage.
1. Carefully remove all parts from the carton. Your bow should
include the following (Fig 1):
2 bow tail sections
1 top bow section (unfold upon removing from carton)
Replacement LED bulbs and light clips
6. To electrically connect the sections, locate the uncapped
coaxial connectors on each of the sections. Align the male
ends to the female connectors as shown in Fig 6 and connect
them together. Slide the screw cover from the “male”
connector over the “female” connector and tighten.
You have now completed the assembly of the bow.
4. Unfold and insert the hooks of the bow’s inner tail sections
(Fig 4).
5. Connect the bow tail sections onto the top bow sections by
guiding the two outer prongs on the tail section into the
corresponding metal sleeves; while inserting the center
support hook into the top bow section (Fig 5).
Fig 1
2 bow tail
section
Replacement LED bulbs and light clips
Top bow
section
Fig 2
3. Insert the center hook of the top bow section to retain its
structure (Fig 3).
Fig 3
Fig 4
Fig 5
NOTE: Check the item for any loose, unlit or damaged bulbs.
Although it will still operate, the bulbs must be replaced
promptly to ensure the performance and life expectancy of the
item.
7. To illuminate, fully insert the plug into a working GFCI outlet
or an outdoor rated extension cord.
Fig 6
11.5”
2014 THD.com
Outdoor Bow Sculpture Instruction Sheet (English)
Date: 4/8/14
11.5”