Instructions / Assembly

ASSEMBLY:
LOCKING PIN
MEANS IT’S LOCKED
"Click" to lock
in place
INSERT BOTH SECTIONS
AT THE SAME TIME
Step 1 Step 2
Step 6
Step 7
Step 8
Step 9
INSERT THE HIP INTO THE BASE
SUPPORT, THEN PUSH THE
LOCKING PIN TO LOCK IN PLACE
ALIGN THE PLUG AND ATTACH THE UPPER
SECTION INTO THE BOTTOM SECTION,
THEN PUSH THE LOCKING PIN TO LOCK IN
PLACE
RELEASE THE SITTING
SKELETON (PART D)
INSERT 2 STAKES INTO THE
GROUND FOR SUPPORT
HH
H
A
B
H
INSERT 2 STAKES THROUGH THE
BASE AND INTO THE GROUND AS
SHOWN FOR SUPPORT
LOCKING
PIN
Step 3
Step 4
Step 5
1 2
3
4
TURN SWITCH
TRY ME
JACK
TO ON POSITION
Step 10
B
B
C
A
G
F
E
F
D
E
E
D
SET-UP AND OPERATING INSTRUCTIONS FOR
THE SET OF 2 SKELETON PIRATES
SKU#1004 176 588
INSTRUCTION MANUAL
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-527-0313, 8 a.m. to 5 p.m., EST, Monday-Friday or email at
[e-mail].
TM
WARNING: This is not a toy and is for decorative purposes only. This item is not intended for use by
children under the age of 14 years. Do not place product near an open fire or heat source such as a
radiator, stove, etc.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
READ CAREFULLY & RETAIN FOR FUTURE REFERENCE!
SAFETY INSTRUCTIONS:
1. All cautions in these operating instructions should be followed completely.
2. Do not use near water; such as bathtub, laundry tub, kitchen sink, wet
basement or swimming pool, etc.
3. Do not display figure near any heat source such as radiators, stoves,
fireplaces, etc.
4. Display should be serviced by a qualified service person only. Do not
attempt to service this unit beyond what is described in the operating
instructions.
5. Take extra care when displaying any figure that may contain small parts
around small children.
6. Use of this decoration should always be supervised by an adult.
7. Remove batteries when not in use.
BATTERY USAGE:
ADULT SUPERVISION IS RECOMMENDED WHEN CHANGING BATTERIES.
1. Do not mix old and new batteries. 2. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
3. Alkaline batteries are suggested for longer life. 4. Exhausted batteries are to be removed from the product. 5. Dispose of
exhausted batteries with care. 6. Do not dispose of batteries in fire, as they may explode or leak.
CAUTION: Please remove batteries if their power is consumed or if the product is to be left unused for a long period of time.
RECYCLE YOUR BATTERIES: To help protect our environment, we recommend that all batteries be recycled. You can find a
local recycling center by going to: http://earth911.com/hazardous/single-use-batteries/ Or, in the United States call
1-800-CLEANUP for a recycling location near you
A Base Support Rod B Standing Skeleton Legs
and Base
C Standing Skeleton Top
E Barrel - Upper Section F Barrel - Lower Section G Metal Support Rod H Ground Stakes
D Sitting Skeleton
X 1 X 1 X 1
X 1 X 1 X 1
X 1
X 4
BATTERY REPLACEMENT & ITEM FUNCTION:
Battery-powered. Requires 3 “AA” batteries for each skeleton (batteries are included).
1. Remove the battery case cover, which is located on the back of the head. To access the battery compartment, using a small
screw driver, unscrew the safety screw and then remove the battery compartment cover.
2. Clean the battery contacts and also those of the device prior to battery installation.
3. Insert new 3 “AA” batteries with correct polarity and replace cover and safety screw.
4. The ON/OFF switch is located on the battery case. Move switch to “ON” position for sound-activated mode. Clap your hands
or make a loud noise to activate LED lights, motion and play a full version of sounds. Switch to the “OFF” position to activate
the Try Me feature and then press the Step Pad (sold separately) for short-version demonstration.
5. Replace batteries if the movement becomes slow, LED’s become dim or sound is distorted or faint.
04252019_2008486
Printed in China
TROUBLE SHOOTING:
Problem Solution
If you are still experiencing problems with the product please call 1-877-527-0313 for further assistance.
The product does
not work
The Sound Sensor
does not work
1. Check if the positive and negative terminals of the battery are installed correctly.
2. Check whether the battery is dead. Replace the new batteries and try again.
1. Check the ON/OFF switch is located in the "ON" position.
2. Check if the triggered sound is too far from the product, please keep the distance
between the sound and the horse at 39.5 in (100cm).
3. Check if the triggered sound is too small, please activate the product with a
trigger sound of more than 90 decibel.