Instructions / Assembly

Each carton contains one top section, one bottom
section (larger trees include one or more middle
sections) and a tree stand.
1. Unfold the tree stand and insert the eye bolts.
Remove packing material from ends of poles. Put
bottom section pole into tree stand making sure it is
seated properly (Figure 1). Tighten eye bolts until
bottom section is held securely.
2
. Insert the middle section of the tree into the bottom
section. (If your tree has more than one
middle section, please refer to SPECIAL
NOTE ABOUT GIANT TREES below.)
Make sure that the light cord(s) hang
straight down with no loose slack that
could interfere with branch hinges.
3. Insert the tree top into the plastic pole cap
of the middle section center pole.
4. (Figure 2) Connect the male end of the light
string cord from the middle section into the
female end of the light string cord of the
bottom section. Connect the male end of
the light string cord from the top section
into the female end of the light string cord
of the middle section. Note that the male
and female connectors are keyed and will
only connect in one direction. After
connection, twist closed each connector
nut securely.
GIANT TREES that include additional
sections will also have additional light string
cord connections.
5. SHAPING: For best results, shape your
tree with the lights on. Branches should fall
into place during assembly. If any branches
remain upright, gently lower them into
proper position (Figure 3). See
IMPORTANT NOTE below.
Each branch must be shaped to a natural position
by spreading out the tips. Please follow Shaping
Instructions on next page for proper shaping
technique.
SPECIAL NOTE ABOUT
GIANT TREES
Some of the larger trees in our product line will include
more than one middle section. If your tree contains
more than one middle section, note that each section
will be numbered in ascending order. The tree bottom
section (which inserts into tree stand) will be number
1. The next section as you build up, will be number 2.
Section 3 will follow until assembly is completed by
inserting tree top section.
Fig. 1
Fig. 2
Fig. 3
Important Note: When lowering branches be
extremely careful not to tangle wire in gap
between branch and bracket.
BULB REPLACEMENT
INSTRUCTIONS
1. Unplug light string from power source.
2. Pull up on the Bulb Lock unlatching the
bulb from the bulb socket. Gently pull the
bulb straight out.
3. Carefully insert new bulb into socket
(bulb is keyed and only goes in one way)
and push down Bulb Lock until it snaps
into place.
D
UAL COLOR TREE
O
PERATING INSTRUCTIONS
The foot switch operates the functions of
the lights. There are five functions, each
one is activated with the press of the foot
switch. Functions occur in the following
order:
FIRST button press turns on steady
Soft White lights
SECOND button press turns on steady
Multicolor lights
THIRD button press turns on fading
Soft White lights
FOURTH button press turns on fading
Soft White to Multicolor
FIFTH button press turns lights OFF
Light functions always follow this sequence.
Only Dual
Color trees
include foot
switch
Low Voltage LED Trees
3