Instructions / Assembly

If the new lamp base does not fit in lampholder, follow these steps:
a) Remove the base of burned out lamp by straightening lamp leads and
gently pull lamp out.
b) Thread leads of new lamp through holes in old
base with one lead in each hole.
c) After lamp is fully inserted into ase, bend each lead
up, like other lamps in the light set so that the leads
will touch the contacts inside the lampholder.
CAUTION! – ALWAYS UNPLUG YOUR TREE FROM ITS
POWER SOURCE BEFORE ATTEMPTING FUSE AND BULB
REPLACEMENT.
Care and Cleaning
Step 1. Remove all ornaments and decorations.
Step 2. Unplug the plug cord from the wall outlet. And remove your power
supply cord with an on/off foot pedal switch from bottom section
(E) and save it.
Step 3. Gently lift the tree top straight up to remove from the center
section and fold all branches towards the pole.
Step 4. Repeat this step for the center and bottom tree sections.
Step 5. Carefully place all tree sections into a shipping box and tape it
shut.
Step 6. Store your tree in a cool, dry place away from sunlight.
UL Model No. TMH12-5(4.93)
Troubleshooting
Problem Solution
The tree
does not
light
Ensure that all tree sections are plugged into each
other and that the tree is plugged into the wall outlet.
Check for blown fuses at the extension cord plug and
the plug fixed on the bottom section (E). Replace as
needed with the replacement fuses provided.
Check for loose, broken, or missing bulbs and replace
as needed with the replacement bulbs provided.
If you are still experiencing problems with the tree
please call 1-877-527-0313 for instructions.