Instructions / Assembly

Safety Information
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be
followed including the following:
a)
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
b) This product is for indoor use only. The electrical rating 0.1 A 120 V
60 Hz.
c) Do not use this product outdoors.
d) This seasonal use product is not intended for permanent installation
or use.
e) Do not mount or place near gas or electric heaters, fireplace, candles
or other similar sources of heat.
f) Do not secure the wiring of the product with staples or nails, or place
on sharp hooks or nails.
g) Do not let lamps rest on the supply cord or on any wire.
h) Unplug the product when leaving the house, or when retiring for the
night, or if left unattended.
i) This is an electric product – not a toy! To avoid risk of fire, burns
personal injury and electric shock it should not be played with or placed
where small children can reach it.
j) Do not use this product for other than its intended use.
k) Do not hang ornaments or other objects from cord, wire, or light
string.
l) Do not close doors or windows on the product or extension cords as
this may damage the wire insulation.
m) Do not cover the product with cloth, paper or any material not part of
the product when in use.
n) This product is equipped with push-in type lamps. Do not twist lamps.
o) This product employs overload protection (fuse). A blown fuse
indicates an overload or short-circuit situation. If the fuse blows, unplug
the product from the outlet. Also unplug any additional strings or
products that may be attached to the product. Replace the fuse as per
the user servicing instructions (follow product marking for proper fuse
rating) and check the product. If the replacement fuse blows, a
short-circuit may be present and the product should be discarded.
p) Read and follow all instructions that are on the product or provided
with the product.
q) SAVE THESE INSTRUCTIONS.
CAUTION! – ALWAYS UNPLUG YOUR
TREE FROM ITS POWER SOURCE BEFORE
ASSEMBLING OR DISASSEMBLING.
CAUTION
a) To reduce the risk of electric shock, use only with the
power-supply cord provided or with a cord set intended for indoor
use.
b) Do not use a cracked, frayed, or damaged cord. Inspect the cord
periodically.
c) Do not abuse cord – Do not carry product by the cord or yank or
pull it to disconnect from the outlet.
d) Disconnect the product from the outlet when not in use.
6.5FT FESTIVE PINE WITH 250L MULTI-COLORED
LED
SKU# 1004339551
Package Contents
A. Tree top
Qty: 1
B. Tree center
Qty:1
C. Tree bottom
with base
Qty:1
D. Legs of Tree base
Qty: 4
E. Fuse
Qty:2
F. Replacement
bulb
Qty:6

Assembling the tree stand
Step 1. Choose a location near a wall outlet.
Step 2. Insert and slide the legs upward into the slots of the base until firmly
secured. (Note: The base is already on the tree section (C).
Assembling the tree
Please remove protective covers from the base of the pole for each tree
section before assembling.
Step 1. Carefully insert the middle section (B) of the tree into the
bottom section (C). (See Fig. 1)
Step 2. Insert the top section (A) into the middle section (B). (See Fig.
2)
Step 3. Insert the male connector of the middle section (B) into the
female connector of the top section (A), the male connector of
the bottom section (C) into the female connector of the middle
section (B) in right direction properly and tightly according to
the magnified drawing on Fig. 5) . (See Fig.3,4,5)
Pre-Assembly
Assembly