Manualshelf

Use and Care Manual

ManualsBrandsHome and Garden Spas ManualsHot Tubs5-Person 14 Jet Round Hot Tub Spa with LED Lighting and Waterfall Feature
21222324252627282930
For technical support and assistance, call 844-894-6659
27
Sleep Mode
The water heats to 20 ̊F below the pre-programmed temperature setting
The water heats during filtration cycles only
“SL” is displayed on the topside controls
DO NOT PUT YOUR SPA IN SLEEP MODE WHEN THE AMBIENT TEMPERATURE IS 40º F OR LOWER!
Sleep Mode can signicantly reduce energy consumption because the water only heats during lter cycles and stops heating when
the water temperature is 20 ̊ F below the pre-programmed temperature setting. For example, if your pre-programmed temperature
setting is 100º F, during the filtration cycle your water will heat to 80º F. If the filtration cycle times out before the water temperature
reaches 80º F, the filtration cycle will end regardless of the water temperature. Sleep Mode is ideal when the weather is warm or when
the spa will not be in use for a prolonged period of time. When your spa is in Sleep mode, the water temperature ashes alternately
with “SL”on the display when the pump is running on low speed, after diagnostic testing, during or a ltration cycle, or when you
press the “Cool” button once. Otherwise, “SL” will be displayed on the topside controls.
Freeze Protection
If the water temperature falls to 44º F, the spa will automatically turn on and will run for 4 minutes after the water temperature reaches
46º F to prevent freezing. If your spa is in Sleep Mode when the ambient temperature is 40º F or lower, the water temperature will
likely operate in Freeze Protection Mode for extended periods if not continuously.
When the display on the topside control ashes the spa is in programming mode. After you press one button, you should wait ve
seconds before you press a dierent button. For example, if you only press the “Light” button ,only the light function changes. If
you only press the “Cool” button, only the temperature changes. But you press the “Light” button and immediately press the “Cool”
button the operating mode will change. Waiting 5 seconds between pressing the “Light” and “Cool” buttons will prevent you from
accidentally changing the operating mode.
It may be dicult to read the topside display in bright sunlight. Standing under an umbrella can block direct sunlight and increase
visibility.
SL