User's Manual

Page 4

OEM Responsibility

OEM Responsibility to the FCC Rules and Regulations

The Zigbee Module has been certified per FCC Part 15 rules for integration into products

without further testing or certification. To fulfill the FCC certification requirements the OEM of

the Zigbee Module must ensure that the information provided on the Zigbee Label is placed on

the outside of the final product.

The Zigbee Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the

module is installed inside another device, then the outside of the device into which the module

is installed must also display a label referring to the enclosed module. This exterior label can

use wording such as the following:

“Contains Transmitter Module FCC ID: HHC-65A10”

“Contains FCC ID: HHC-65A10”

The OEM of the Zigbee Module must only use the approved antenna, which has been certified

with this module.

The OEM of the Zigbee Module must test their final product configuration to comply with

Unintentional Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.

Section 7.1.5 of RSS-GEN

Operation is subject to the following two conditions:

1) this device may not cause interference, and

2) this device must accept any interference,

including interference that may cause undesired operation of the device.