- HAI OmniPro II Owner's Manual
Table Of Contents
- INTRODUCTION
- OVERALL DESCRIPTION
- SECURITY SYSTEM OPERATION
- Disarming the Security System and Silencing Alarms
- Arming the Security System
- Using Shortcut Keys
- Quick Arm
- Bypassing Zones
- Restoring Zones
- What To Do When You Come Home
- What Happens When the Alarm is Activated
- Emergency Keys
- Duress Code Entered or Duress Alarm Activated
- Alarm Reset
- Alarm Cancel
- Trouble Indications
- Codes
- Duress Code
- Panic Switches
- Area Arming
- GOTO Area
- Testing Your System
- CONTROL
- Control Commands
- About UPB
- HAI Lighting Control (HLC) Format
- About CentraLite
- About Lutron RadioRA
- About ALC
- About X-10
- House Codes
- Unit Numbers
- Scrolling Through Names
- Controlling Units
- Timed Commands
- Status of a Unit
- Internal Flags
- Controlling Outputs
- All On / Off
- Leviton Scene Control
- Buttons
- Temperature Control
- HAI RC-Series Thermostats
- Programmable Energy Saver Modules (PESMs)
- Temperature Alarms
- Humidity
- Status
- Event Log
- Messages
- TELEPHONE CONTROL
- Telephone Interface
- In-House Phones
- Remote Phones
- Phone Access Denied - Remote Lockout
- Alternate Method
- Main Menu
- 1 - Control
- 2 - Security
- 3 - Button
- 4 - All
- 5 - Temperature
- 6 - Status
- 7 - Events
- 8 - Message
- 9 - Good-Bye
- Panic Button over the Phone (# # # # # #)
- Emergency Dial-Out
- Digital Dialer
- Voice Dialer
- PC Access
- Built-In Ethernet Port
- Controller IP Address, Port Number, and Encryption Key
- OmniPro II Ethernet Connections
- Connecting to Network via PC Access
- Dynamic DNS
- SETUP
- UNDERWRITER'S LABORATORIES REQUIREMENTS
- FEDERAL COMMUNICATION COMMISSION NOTICE:
- CANADIAN INDUSTRY CANADA NOTICE
- APPENDIX A - DIAL OUT PLANNER
- APPENDIX B - TEXT DESCRIPTION CHARACTER CODES
- APPENDIX C - VOICE DESCRIPTION CODES
The zone will be displayed and you will be prompted for the state of the zone:
IF Front Door:
0=SECURE 1=NOT RDY
Program Time Clock Conditions
Select the 9 (TIME) key to specify that the program should only execute if a specified Time Clock is either On or Off. The
display prompts you for the Time Clock number:
ENTER TIME CLOCK:
1-3
Enter the Time Clock number followed by the ' # ' key.
Next, specify the state of the time clock:
IF TIME CLOCK 1:
0=OFF 1=ON
Program Other Conditions
Select the # (OTHER) key to select a condition from a list of other conditions.
SELECT CONDITION:
NONE
↓
Choose "NONE" when editing a program and choose not to conditionalize the program.
SELECT CONDITION:
NEVER
Choose "NEVER" if you wish to temporarily deactivate a program without deleting it.
Other conditions include:
• IF LIGHT
• IF DARK
• IF ENERGY LO
• IF ENERGY MID
• IF ENERGY HI
• IF ENERGY CRIT
• IF PHONE DEAD
• IF PHONE RING
• IF PHONE OFFHK
• IF PHONE ONHOOK
• IF AC PWR OFF
• IF AC PWR ON
• IF BATTERY LOW
• IF BATTERY OK
Page 70