Installation Guide

Page 5

Venting Methods

This built-in range hood is factory set for venting through the roof or wall. For non-vented (re-circulating) •

installations, see Ductless Conversion (Non-Vented) below.

Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed.•

IMPORTANT:

NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or •

garages. All exhaust must be ducted to the outside.

Use metal/aluminum duct work only. •

Fasten all connections with sheet metal screws and tape all joints with certiﬁed Silver Tape or Duct Tape.•

Use caulking to seal exterior wall or roof opening around the cap.•

Round Duct

Wall Cap

Round Elbow

Roof Cap

24” to 30” Above

Cooking Surface

Range Hood

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX