Instructions / Assembly

1/3

DINING CHAIR DINING CHAIR

UC-4 UC-4

PARTS LIST

HARDWARE :

G×1

H×1

I×2

A×9

B×9

D×1

C×1 E×4

Φ8

Front Legs

Seat

Back

M8x55MM

M8x75MM

Shorter Screw

Longer Screw

Lock washer

Flat washer

Allen key

F×4

M8x60MM

Medium Screw

PAGE 1
DINING CHAIR UC-4 HARDWARE : A×9 Φ8 Flat washer PARTS LIST D×1 C×1 B×9 Φ8 M8x55MM M8x60MM Shorter Screw Medium Screw M8 Lock washer Allen key H×1 G×1 Back E×4 I×2 Seat 1/3 Front Legs F×4 M8x75MM Longer Screw
PAGE 2
1 Put chair back on a clean flat surface. H Place seat pad against chair back as shown in diagram. C D A B 60% D A B Secure center holes of the seat pad to chair back by using SHORTER SCREW (D) with Washer (#A,B). DO NOT FULLY TIGHTEN. First HAND tighten then tightened using key up-to 60-80% only at this stage. G 2 C 60% F F A Secure both corner holes of the seat pad to the chair back by using A B B LONGER SCREWS (F) with washers ( #A,B). DO NOT FULLY TIGHTEN.
PAGE 3
Put chair in the upright position and SIT ON THE CHAIR to press downwards on the seat pad ensuring that all 4 feet touch the ground and chair is leveled. 4 Proceed to tighten all screws making sure the chair remainslevel when tightening. Check that all screws are tight on a regular basis to ensure chair remains level and secure. 5 TROUBLESHOOT One screw is in and other screw does not go in. Or Holes are not align. 1.