Instructions / Assembly

Installation

Attaching the mounting unit to the

junction box

Installing the light fixture

Making the electrical connections

 Screw the support screws (BB) into the mounting unit

(AA). Secure with the two nuts (DD).

 Attach the mounting unit (AA) to the junction box (not

included) with mounting screws (CC).

 Connect the copper wire from the light fixture (A) to the

mounting unit (AA) by securing it with the pre-installed

ground screw.

 Connect black wire to black (power) wire coming out of

the junction box, the white wire (neutral) to white wire

coming out of the junction box and copper/green wire to

the ground wire with wire nuts (FF) and secure with

electrical tape (not included).

 Secure the canopy (A) to the junction box by placing the

holes in the canopy (A) over the support screws (BB).

Secure with the ball nuts (EE) as shown.

 Screw the crystal shades (B) to the lamp holder.

NOTE: The support screws (BB) on the mounting unit

(AA) should protrude out away from the junction box.

NOTE: If the wires from the fixture are the same color,

attach the side with markings or letters to the black

(positive) wire and the other to the white (neutral) wire.

Adjusting the height of the

light fixture

 To shorten the length of the cords push the cord up into

the pipe nipple and it will lock automatically.

 To lengthen the cords push the tip of the pipe nipple to

release the lock so that cord can be pulled out.

Please contact 1-800-986-3460 for further assistance.

HOMEDEPOT.COM/HOMEDECORATORS