Instructions / Assembly

1. Adjust excess cord by wrapping it around spindle bracket (B)

just below the socket adapter (A). Position the last wrap

so the cord will hang in the center of your recessed light

fixture.

ASSEMBLY INSTRUCTIONS

Before beginning assembly of product, make sure all parts are present. Compare parts with package

contents list and diagram above. If any part is missing or damaged. Do not attempt to assemble the

product. Contact customer service for replacement parts.

Estimated Assembly Time: 10-15 minutes

Helpful Tools:

Recessed

light socket

2.Screw the adapter (A) into the light bulb socket in your

recessed light fixture.

3.After finger loosening the compression nut (D) by turning it

counter-clockwise, slide the canopy (C) up the cord and

against the ceiling.

PREPARATION

HELPFUL HINT: If the canopy does not sit tight against the

ceiling, loosen the compression nut (D). GENTLY pull down on

the cord to flex the spring arm (B), then slide the canopy (C),

back up and re-tighten.

4.To hold the canopy in place against the ceiling, finger tighten

the compression nut (D) by turning it clockwise.

Ceiling

CAUTION: Do not over-tighten the compression nut (D).

5.Attach shade(F) to lamp cup (G) and then screw on the socket

ring (E) clockwise until tight.

Fig.1

Fig.2

Fig.5

Bulb (not included)

Ceiling

Recessed

light fixture

Fig.3

Fig.4