Installation Guide
16
Operation
Operation
3 4
Adjusting the heater
NOTE:
To change between °F and °C press and hold the
TIMER button on the control panel for 3 seconds.
Push the Power button to supply power to all
functions of the replace and put the insert in a
standby mode.
Push the Power button again to turn off all functions.
1
Powering the replace
NOTE:
Holding the Power button on the control panel for
10 seconds will disable the heater function.
NOTE:
All previous settings are held in memory, so the
next time you power up the replace, the unit will turn on
with the same settings.
Pressing the Timer button will cycle through the timer
settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,
8H, 9H and off (00).
Setting the timer
NOTE:
The control panel can be accessed at the upper-right corner of the insert.
/
Each ame color option has speed options available.
Setting S1 is slowest ranging up to setting S5 which
is the fastest.
5
Adjusting the ame speed
The replace contains three infrared quartz heating ele-
ments.
The thermostat setting range is 62°F - 82°F (17°C - 27°C)
or continuously ON. Set the heater to (00) to use the ame
effects without the heat.
The thermostat is adjustable by 2°F or 1°C increments.
The “ ” buttons on the control panel and “ +/- ”
buttons on the remote control will increase / decrease
temperature setting.
2
Adjusting the ame
There are 5 brightness levels that can be selected and OFF
(00) setting. Settings F5 - F1 decrease in brightness.