Installation Guide

Assembly (continued)

Using the Left Partition assembly (D) and the Center

Shelf assembly (B), align the previously installed

dowels and cam lock screws into the holes.

Secure by inserting Cam Lock Connectors (DD) into

the pre-drilled holes as shown. Tighten all Cam

Lock Connectors (DD) using a Phillips screwdriver.

Repeat to secure the Right Partition assembly (E)

onto the Center Shelf assembly (B).

Locate the Base Rails (L, I, J, K) and place on a

at surface.

Insert Bolts (NN) through the two-hole Plastic

Connector Blocks (OO) on each rail as shown.

Tighten with the Phillips screwdriver.

Using the Left Surround Rail (F) and the Left Partition

(D), align the previously installed wood dowels and

cam lock screws into the pre-drilled holes.

Secure by inserting Cam Lock Connectors (DD) into

the pre-drilled holes as shown. Tighten using a Phillips

screwdriver.

Repeat the steps above with the Right Surround Rail

(H) and Right Partition (E).

Attaching the center assembly

Preparing the base

Attaching the front surround panels