Instructions / Assembly

ManualsBrandsHome Decorators Collection ManualsOutdoorsMartingale Espresso Rectangular Patio Dining Table

MARTINGALE 72" GRC

DINING TABLE

Please read over this instruction manual as it will save time in the

assembly of this product.

Note: Prior to assembly, please open and lay parts out on a clean, soft

flat surface to avoid any damages to the product’s finish.

HDC#:1470910810 MFG#:FTA10006B

page 1-8

Summary of content (8 pages)

PAGE 1
MARTINGALE 72" GRC DINING TABLE HDC#:1470910810 MFG#:FTA10006B Please read over this instruction manual as it will save time in the assembly of this product. Note: Prior to assembly, please open and lay parts out on a clean, soft flat surface to avoid any damages to the product’s finish.
PAGE 2
Caution: The Martingale dining table was made for explicit purpose of providing outdoor functions and is not to be used as a toy. This product is not intended for inclement/severe weather in any form including, but not limited to: rain, hail, sleet, snow and/or wind. Manufacturer recommends that with formidable weather approaching you store and/or cover this dining table. Do not locate product near any open flame. Do not use product as a support. Do not shake, lean or climb on product.
PAGE 3
DO NOT RETURN TO RETAILER IF YOU HAVE ANY QUESTIONS OR CONCERNS PLEASE VISIT OUR WEBSITE AT: www.yotrioint.com OR TOLL FREE AT: 1-800-245-2217 MONDAY-FRIDAY 8:30 AM TO 5:00 PM PACIFIC STANDARD TIME / 11:30 AM TO 8:00PM EASTERN STANDARD TIME Warranty Coverage Requirements: 1. Copy of your Original Store Receipt. 2. Pictures of the damaged parts. 3. You must know the name of your product and any corresponding item numbers as well as the name of the store where you purchased the item. 4.
PAGE 4
Parts Check List Please remove all parts carefully from box and lay out on clean, soft surface to protect product’s finish.Keep protective covering on table top until fully assembled to protect surface.
PAGE 5
A. M6X15 Bolt – 4PC C. M6 Washer – 12PCS B. M6X20 Bolt – 8PC D.
PAGE 6
1. Place the table legs (2) upside down on a soft surface. Insert the table legs (2) into the leg connector (3) in the direction of the arrows in the below image. Secure the leg connector (3) to the table legs (2) using M6x15 bolts (A) and M6 washers(C). Use the hex wrench (D) to loosely tighten all the bolts.
PAGE 7
. 2. Lay the table top (1) upside down on a soft surface. Attach the assembled table legs (2) to the table top (1) using M6x20 bolts (B) and M6 washers (C). Use the hex wrench (D) to loosely tighten all the bolts.
PAGE 8
3. Once all the bolts are in place. Fully tighten all the bolts with the hex wrench (D). Turn the table right side up. Check to ensure the table is tightly assembled and stable before use. 4. Remove the protective covering on the table top (1).