Installation Guide

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Route the wires exiting the top of the fan-motor

assembly (D) through the canopy ring (K) (make sure

the slot openings for the canopy ring (K) are on top).

□ Insert the ball/downrod (B) through the canopy (C) and

slide the decorative motor collar cover (F) onto the end

of the ball/downrod (B). Make sure the slots on the

canopy (C) are on top.

□ Route the wires exiting the top of the fan motor

assembly (D) through the downrod (B) as shown.

□ Loosen, but do not remove the setscrew (DD) on the motor collar

(M), on top of the fan-motor assembly (D) by turning it counter-

clockwise.

□ Install the downrod (B) by inserting it into the motor collar (M),

and turning it clockwise until it is tight.

□ Re-tighten the setscrew (DD) on the motor collar (M) on top of the

fan-motor assembly (D) by turning it counterclockwise.

NOTE: This fan is equipped with a safety tab (EE). Should

the setscrew (DD) ever become loose while the fan is

running in reverse, the safety tab (EE) will engage and

stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(DD) must be completely tightened

□ Remove the canopy ring (K) from the canopy (C) by turning

the ring clockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (LL) located in the “L

shaped” slots.

□ Remove and save the two canopy screws (JJ) in the round

holes. This will enable you to remove the mounting bracket

(A).