Instructions / Assembly

Assembly - Close-To-Ceiling Mount

Close-to-Ceiling Mounting Routing the wires

1 2

□ Remove the canopy ring (FF) from the canopy (C) by turn-

ing the ring counter-clockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (JJ) located in the “L

shaped” slots.

□ Remove and save the two canopy screws (II) in the round

holes. This will enable you to remove the mounting

bracket (A).

□ Remove the decorative canopy bottom cover (L) from the

canppy (C) by depressing the three studs.

□ Remove three of the six screws and lock washers (KK)(every

other one) securing the motor collar to the top of the fan-

motor assembly (E).

□ Route the wires exiting the top of the fan-motor assembly

(E) through the rubber gasket (CC) aligning the holes in the

rubber gasket (CC) with the three screw holes in the fan-

motor assembly (E).

□ Route the wires exiting the top of the fan-motor assembly

(E) through the canopy ring (FF), and the canopy (C) (make

sure the slot openings for the canopy ring and canopy are on

top). Place the canopy (C) over the collar (M) at the top of the

motor (E).

□ Align the mounting holes in the canopy (C) with the screw

holes in the motor (E) and fasten using the three screws and

lock washers (KK) (removed previously). Tighten the mounting

screws securely.