Installation Guide
12
Assembly - Attaching the Accessories
Attaching the light kit tter assembly
2
□ Remove one screw (LL) from the light kit pan, and loosen, but
do not remove the other two screws.
□ Connect the wires from the light kit tter assembly (H) to
the wires from the fan motor assembly (G) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□ Push the light kit tter assembly (H) up to the light kit pan so
that the two loosened screw heads t into the keyhole slots.
Turn the light kit tter assembly (H) clockwise to secure.
□ Re-install the screw that was removed in the rst step.
□ Make sure all the screws are rmly tightened.
LL
G
H
Installing the shade
3
□ Place the glass bowl (I) into the light kit (H), aligning the three
at areas on the top of the ange of the glass bowl (I) with
the three raised dimples in the light kit (H). Turn the shade
clockwise until it stops.
H
I
WARNING: Do not overtighten when installing the shade into the
light kit. Allow the shade to cool completely before removing.