Instructions / Assembly

Mounting the fan-motor assembly

(standard mount)

□ Align the locking slots of the canopy (C) with the two screws

(CC) and alignment post (KK) in the mounting bracket (A).

□ Push up the canopy (C) and turn clockwise until the alignment

post (KK) engages to the round hole and the screws (CC)

engage to the key slots.

□ Firmly tighten the two mounting screws (CC).

□ Align the oval shape on the canopy (C) with the canopy bottom

cover (DD). Push up the canopy bottom cover (DD) until the

screw (CC) heads engage to the slots on the canopy bottom

cover (DD) so that the magnetic canopy bottom cover (DD) can

be attached to the bottom of the canopy (C) properly.

WARNING: When using the standard ball/downrod

mounting, the tab in the ring at the bottom of the

mounting bracket must rest in the groove of the hanger

ball. Failure to properly seat the tab in the groove could

cause damage to the wiring.

Assembly - Hanging the Fan (continued)

Wrapping the extra wire

□ Gently wrap the excess wire around the mounting bracket (A).

□ Secure with electrical tape.

NOTE: Follow this step ONLY if you did not cut the extra length off

from the wires coming from the ceiling fan.

NOTE: The magnet is pre-attached on the canopy

bottom cover for you to remove and install easily.