Instructions / Assembly

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Pull off the canopy bottom cover (DD) from the canopy (C).

□ Loosen the two canopy screws (CC) located in the

bottom of the mounting bracket (A), and turn the canopy

counterclockwise to remove the mounting bracket (A) from

canopy (C).

□ Route the wires exiting the top of the fan motor

assembly (E) through the decorative motor collar cover

(D) and then the center of the canopy bottom cover

(DD).

□ Make sure the opening of canopy (C) is on top and

insert the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor

assembly (E) through downrod as shown.

□ Loosen, but do not remove, the setscrew (EE) on the collar (FF)

on top of the fan-motor assembly (E).

□ Install the downrod (B) by inserting it into the motor collar (FF),

and turning it clockwise until it is tight.

□ Re-tighten the setscrew (EE) on the collar (FF) on top of the fan-

motor assembly (E).

NOTE: This fan is equipped with a safety tab (GG).

Should the setscrew (EE) ever become loose while

the fan is running in reverse, the safety tab (GG) will

engage and stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(EE) must be completely tightened.

NOTE: The magnet is pre-attached on the canopy

bottom cover for you to remove and install easily.