Instructions / Assembly
□ Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Care and Cleaning
□ To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the glass
and surface of the fixture.
□ To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at
the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and interior
surface of the fixture.
Troubleshooting
Maintenance
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Problem Possible Cause Corrective Action
In motion sensing mode, the light
does not turn on when there is
motion.
Wall switch or circuit breaker is off.
Turn on a switch or circuit breaker.
Light bulb may be dead. Test the light bulb in a known
working light fixture.
Light bulb is loose. Tighten the light bulb in the socket.
Incorrect or loose wire connections. Check wire connections.
Too much sunlight is shining into photocell
sensor in the early evening.
Relocate fixture away from a
western facing wall.
Too much light is shining onto photocell sensor
due to another light source, such as a street
lamp or other light fixture.
Eliminate or turn off other light
source, block other light source
from shining onto photocell sensor,
or relocate fixture.
In motion sensing mode, the light
stays on continuously.
False triggering caused by a heat source, such
as a heater or dryer vent, or heated swimming
pool.
Eliminate heat source or relocate
fixture.
The light comes on for no apparent
reason.
Street or sidewalk traffic is triggering motion
sensor.
Lower the sensitivity.
False triggering caused by a heat source, such
as a heater or dryer vent, or heated swimming
pool.
Eliminate heat source or relocate
fixture.
The fuse blows or circuit breaker
trips when the light is turned on.
There are crossed wires or power wire is
grounding out.
Check the wire connections.
The light comes on during the
daytime or too early in the evening.
The fixture may be installed in a shaded area,
such as under a porch or eave, preventing
daylight from shining onto the photocell sensor.
Relocate the fixture.