Instructions / Assembly

WARNING:
Perform all leak tests outdoors.
Extinguish all open ames.
NEVER leak test when smoking.
Do not use the re pit until all connections
have been leak tested and conrmed no leakage.
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operation(continued)
CAUTION: The gas supply must be turned off at the LP gas supply cylinder when this appliance is not in use.
Leak Check
Regulator / Cylinder
connection
Hose / Regulator
connection
11
Immediately remove any spot or stain.
To clean, wash with a mild soap, rinse with water and let air dry.
Do not use strong solvents or bleach as they may damage the surface.
Use an outdoor cover to extend the life of the item.
Care and Maintenance
CAUTION: Surfaces of re pit can remain extremely hot for a period after use. Allow 45 minutes to cool down before touching or
moving the re pit.
Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water).
Apply several drops of solution where hose attaches to regulator.
Apply several drops of solution where regulator connects to cylinder.
Make sure all re pit and light valves are OFF.
Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
Turn cylinder valve OFF.
If leak is at hose/regulator connection: tighten connection and perform another leak test. If bubbles
continue appearing, the hose should be returned to the place of purchase.
If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another leak
check. If you continue to see bubbles after several attempts, cylinder valve is defective and should be
returned to cylinder’s place of purchase.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loosened or removed, you must perform a complete leak test.