Use and Care Manual

12
Care & Cleaning
□ Always turn the heater OFF and unplug the power cord from the outlet before cleaning.
□ Cleaning of the control panel, located in the upp right-hand corner of the fireplace behind the sliding control panel cover, is to be done
only using a soft cloth, slightly dampened in water (if needed, a small amount of dish soap can be added to the water) and dried using
a clean, dry soft cloth. Cleaning of the screen diffuser is to be done using only water and lint free cloth. DO NOT use any abrasive
controls and the diffusing screen.
Maintenance (continued)
Disconnect power before servicing.
Any electrical re-wiring of this appliance must be done by a qualified electrician. This wiring must be done in
accordance with local codes and/or in Canada with the current CSA C22.1 Canadian Electrical Code, and for US
installations, the National Electrical Code ANSI/NFPA NO 70.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding and securing
locations must be followed.
DANGER
CIRCUIT DIAGRAM
WARNING: Disconnect power before servicing.
WARNING: DISCONNECT POWER BEFORE SERVICING.
AC120V/60Hz
L
N
N
L
RLY3
RLY4
RLY1
RLY2
CIRCUIT
BOARD
THERMAL
CUTOFF
THERMAL
FUSE
HEATER
ELEMENT
FAN
HEATER
FLAME EFFECT
MOTOR
EMBER
BED LED
FLAME LED
POWER I/O
FLAME I/O
HEATER I/O
TIMER I/O
GND
AVERTISSEMENT: COUPLEZ L’ALIMENTATION AVANT D’EFFECTUER L’ENTRETIEN.
AC120V/60Hz
L
N
N
L
RLY3
RLY4
RLY1
RLY2
CARTE DE
CIRCUIT
IMPRIMÉ
THERMAL
CUTOFF
FUSIBLE
THERMIQUE
ÉLÉMENT
CHAUFFANT
RADIATEUR DU
VENTILATEUR
MOTEUR D’EFFET
DE FLAMME
CALENTADOR
DE VENTILADOR
MOTOR DE
EFECTO
DE LLAMAS
DEL DU LIT
DE BRAISE
LED DE LECHO
DE BRASAS
DEL DE FLAMME
E/S DE PUISSANCE
E/S RÉCHAUFFEUR
E/S FLAMME
E/S TEMPS
GND
ADVERTENCIA: DESCONECTE LA FUENTE DE ALIMENTACIÓN ANTES DE DAR MANTENIMIENTO.
AC120V/60Hz
L
N
N
L
RLY3
RLY4
RLY1
RLY2
PLACA DE
CIRCUITOS
CORTE
OPERACIONES
TÉRMICO
FUSIBLE
TÉRMICO
ELEMENTO
CALENTADOR
LED DE LLAMAS
E/S DE ALIMENTACIÓN
E/S DE LLAMAS
E/S CALENTADORA
E/S TIEMPO
GND