2 Light Flush Mount Keswick Home Depot SKU 170-312 (UPC 718212271797) (Modern Brass Finish) INSTRUCTION MANUAL LA-2037E/S/F Page 1
Thank you for purchasing this Home Decorators Collection interior light fixture. This product has been manufactured with the highest standards of safety and quality. FEATURES: 1. Traditional 2 Light Flush Mount in Modern Brass Finish. 2. Timeless Elegant Design. 3. Easy to assemble and install. QUESTIONS, PROBLEMS, MISSING PARTS: Before returning to your local Home Depot, please call our Customer Service Team at 1-800-986-3460 or visit www.homedepot.com.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-800-986-3460 or visit www.homedepot.com. Please reference your SKU (170-312 Modern Brass fixture) or UPC (718212271797 Modern Brass fixture).
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 1 Ceiling Pan (#1) 1 Glass Shade (#3) 1 Finial (#5) 1 Cap (#4) 1 Nipple (#2) ASSEMBLY INSTRUCTIONS: 1. Shut off power at the fuse box or circuit breaker box. Remove the old fixture from ceiling, including the mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
ASSEMBLY: 1. Ceiling Pan 2. Nipple 3. Glass Shade 4. Cap 5.
PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 2 Mounting Screws (#7) 1 Crossbar (#10) 1 Ground Screw (#8) 2 Outlet box Screw (#9) 3 Wire Connector (#11) INSTALLATION INSTRUCTIONS: 1. Thread the two Mounting Screws (#7) about 1/4” into the pre-drilled holes in the Crossbar (#10) spaced the same distance apart as the holes in the Ceiling Pan (#1). 2. Attach the Crossbar (#10) to the Outlet Box (#6) using the two Outlet Box Screws (#9) as shown.
INSTALLATION: 6. Outlet Box 11. Wire Connectors Ground Wire 10. Crossbar 9. Outlet Box Screws Black Wire 8. Ground Screw White Wire 7. Mounting Screws 1.
TROUBLESHOOTING: Bulb will not light. Fuse blows or circuit breaker trips when light is turned on. Possible Cause 1. Bulb is burned out. 2. Power is off. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Faulty wire connection. 3. Check wiring. 4. Faulty switch. 4. Test or replace switch. Crossed wires or power wire Check wire connections. is grounding out. PRODUCT MAINTENANCE: 1.