Instructions / Assembly

6
Installation
1 2
3
Installing the backplate Making the electrical connections
Installing the xture body
Fasten the open end of the ground wire (bare
copper or green wire) to the ground wire from
the junction box or the ground screw (CC) on
the backplate (EE).
Connect the black wire of the power supply to
the black wire of the xture and connect the
white wire of the power supply to the white
wire of the xture.
EE
A
NOTE: Always use the wire nuts (AA) to connect wires and
push all excess wires and connections back into the junction
box
(not included).
Remove the backplate (EE) from the xture body
(A). Using the backplate (EE) as a guide, mark
on the wall with the outlet box (not included)
the locations for anchors (GG) with a pencil (not
included). Drill a 1/4 in. hole at marks, then
insert anchors (GG). Secure the backplate (EE) to
the outlet box with the outlet box screws (BB).
Align the keyholes in the backplate (EE) with the
anchors (GG) and insert the tapping screws (FF).
Carefully unpack the xture. Lay out all the parts
on a clean surface.
WARNING: Turn off power at the main fuse box.
DD
EE
GG
BB
FF
EE
CC
AA
WHITE WIRE WHITE WIRE
FROM FIXTURE
FROM FIXTURE
FROM CANOPY
GROUND WIRE
BLACK WIRE BLACK WIRE
GROUND WIRE
FROM HOUSE
FROM HOUSE
FROM HOUSE
Attach the xture body (A) to the
backplate (EE). Then tighten the
mounting screws (DD) by using a
Phillips screwdriver (not included).