Instructions / Assembly

Operation

WARNING: Do not short-circuit, disassemble, heat up,

connect improperly, or dispose of used batteries in ﬁre. Do

not recharge or mix batteries with used or other battery

types. Immediately remove used batteries.

WARNING: a)The cells shall be disposed of properly,

including keeping them away from children; and

b) Even used cells may cause injury.

NOTE: After the AC power is on, do not press any other button

on the remote control before pressing the (FAN ON/OFF)

button. Doing so will cause the procedure to fail.

Should you desire to use another remote control (J) unit with your

new fan, install one using the steps below:

Turn the main power source off to begin the learning process.

□

Return the power to the unit.

□

Within 30 seconds of turning the fan’s AC power ON, press and

hold the button for 5 seconds to enter the learning function.

Once the receiver has detected the set frequency, the down

light of your fan, if applicable, will blink twice. There is no

indication if your fan is not equipped with a light.

□

REMOTE CONTROL OPERATING INSTRUCTIONS

Install a CR2032 (L) into the remote control (J). To prevent damage

to the remote control, remove the battery if not used for long

periods of time.

LEARNING PROCESS

WARNING: Chemical Burn Hazard. Keep batteries away

from children. This product contains a lithium button/coin

cell battery. If a new or used lithium button/coin cell battery

is swallowed or enters the body, it can cause severe

internal burns and can lead to death in as little as 2 hours.

Always completely secure the battery compartment. If the

battery compartment does not close securely, stop using the

product, remove the batteries, and keep it away from

children. If you think batteries might have been swallowed

or placed inside any part of the body, seek immediate

medical attention.