General Residential Installation Instructions LVT
Residential Installation Guide – LVT Click Residential Installation Guide - LVT Click Materials Required for Installation: • Tape Measure • Square Ruler • Utility Knife • Chalk Line • Scrap piece of LVT/P material tapping to tighten joints • Small Hand Roller (Seam Roller) Acceptable Underlayments IVC US’s LVT Click products can be installed directly over most existing floor coverings, except for carpet, laminate, floating floors systems and cushioned vinyl flooring.
Residential Installation Guide – LVT Click Start of Installation It is the installer’s responsibility to inspect the flooring prior to installation to ensure that there are no visual defects. Do not install flooring with visible defects. If visible defects are present, contact your retailer immediately. • Floor must be clean, smooth, flat and dry before installation. • Check the tongue and groove to assure it is free of debris or damage.
Residential Installation Guide – LVT Click Treads, Risers and Ramps Glue down method is required on all treads, risers and wheelchair ramps using IVC US iGrip Adhesive. Apply the adhesive following the manufacturer’s instructions. Install the riser after installing the tread. Install stair nose moldings afterwards to protect the edge of the LVT. Plank Replacement Should one of your planks/tiles become damaged and need to be replaced, follow these simple instructions: 1.